Virtual Dyno "ecuTek log parameters"
 

Dear


How I can use ecuTek log file with virtual Dyno??
What loging parameters I have to chose

Coze most time show me error msg

Rpm
Tps
And more not included at your log file

Also what is the correct smoothing from 0_6?


Thnx

UP

The newer column headers don't work by default. You also need to edit the csv file to make sure the data headers are in the top row and there are some scaling changes you have to make. I can't remember off hand, but you will need to play around a bit.

As for smoothing factor, the lower the value the more accurate it is but more susceptible to error. Probably 2/3 is about right.

Thank

But any more help

I think you have to have a pull with less than 100% TPS and you want a log with just a single pull in it. I use VGI's "MAF Scaling" tool to pull individual WOT pulls out of a longer log. I have then setup the Columns and Profiles tab in the options to match the column headers in the log and it then works.