Schematic for remote start install?
 

Does anyone have info up for doing a remote start in an FR-S yet?

I want to put a basic Compustar 2-way into my 6MT.

I want to do this as well im pretty sure there was a thread about this a while back

These are what I found. **I DO NOT TAKE ANY RESPONSIBILITY FOR ANY OF YOUR INSTALLATIONS**

It goes:
What the wire is
Wire color
Polarity
Where it is located



Battery
WHITE/RED OR WHITE/GREEN
(+)
IGNITION SWITCH HARNESS

Ignition 1
WHITE
(+)
IGNITION SWITCH HARNESS

Ignition 2
GREEN/ORANGE
(+)
IGNITION SWITCH HARNESS

Accessory 1
LIGHT BLUE
(+)
IGNITION SWITCH HARNESS

Starter 1
RED/WHITE
(+)
IGNITION SWITCH HARNESS

Starter 2
WHITE/BLACK
(+)
IGNITION SWITCH HARNESS

Anti-Theft Type
UNIVERSAL IMMOBILIZER

Anti-Theft Descript
THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER

Key Sense
BROWN
(+)
AT BCM MODULE UNDER DRIVERS SIDE OF DASH NEAR KICKPANEL

Neutral Safety
WHITE/GREEN
(+)
AT TCM MODULE HIGH IN DRIVERS KICKPANEL NEAR FIREWALL

Tachometer
RED/BLACK
(AC)
AT OBDII CONNECTOR AT BOTTOM EDGE OF DRIVERS SIDE OF DASH TO RIGHT OF STEERING COLUMN

Parking Lights
TAN
(-)
AT BCM MODULE UNDER DRIVERS SIDE OF DASH NEAR KICKPANEL

Brake Lights
BLUE
(+)
AT SWITCH ABOVE PEDAL

Reverse Lights
ORANGE/WHITE OR PINK
(+)
IN HARNESS IN DRIVERS KICKPANEL

Horn
BROWN
(-)
AT BCM MODULE UNDER DRIVERS SIDE OF DASH NEAR KICKPANEL

Anti Theft TX
WHITE/GREEN
(DATA)
IN HARNESS AT IMMOBILIZER CONTROL MODULE NEAR IGNITION SWITCH

CANbus
PINK
(DATA)
AT BCM MODULE UNDER DRIVERS SIDE OF DASH NEAR KICKPANEL

Rear Defrost
WHITE
(-)
AT BCM MODULE UNDER DRIVERS SIDE OF DASH NEAR KICKPANEL

Let me know if you have access to this PDF


-Benny