Looking for a UEL header 2017+
 

currently have an invidia n1 and was looking for a UEL header to pair with it. I've heard they changed the bolt pattern slightly for 2017+ and newer models so not sure what headers are available for gt86 now

I ordered a ft86 speed factory catted UEL header and am waiting for it to arrive for my 2017. I will let you know if it fits with out modification when I finally get it.

nothing changed with the header fitment

if this was the case why is there a separation of years? also I've seen elsewhere on this forum someone talking about changes made.

They made changes to the design of the tubes for the OEM headers from 17 on up. I think the mounting points remain unchanged.

Had an ft86speedfactory UEL header on my 17, zero fitment issues.

(Its for sale if you're interested.)

Fitment is same, 100%
They changed only the fitment between midpipe and muffler but actually i have a pre-my16 aftermarker midpipe on a 2017 muffler without problems

Nothing as far as mounting points were concerned were changed, the flange between midpipe and rear muffler was changed but this is a moot point if you go catback.

So the only thing that does not fit to 2013-2016 cars is an axle back exhaust, everything else fits assuming you are replacing apples with applies, i.e. front pipe for aftermarket front pipe, factory header for aftermarket header, etc.

alright cool! thanks to everyone. I'll probably just make the exhaust full invidia then.