gauge issue
 

soo all sudden my gauge dash stop working i replace the 7.5 fuse and it blows try 10 it blows,try a 15 and it blows idk what the issue is but i need it cause i cant use my turn signal and the alternator not charging battery :( :cry:

My bet is on the alternator, probably has a short internally and is causing the problem.

soo removing the connections on the alternator and retrying the fuses again would eliminate the shortage ?

Yeah that's what I would try, if it doesnt blow the fuse you know you have a failed alternator

Whatever it is, I wouldn't keep putting bigger fuses in the slot …. or you will find the problem, when something starts smoking...:(

Like suggested, you may wish to check the alternator.

https://www.aa1car.com/library/battery_runs_down.htm

Then, I would look for a short … what is the last electrical thing you did with the car??


humfrz

the alternator is disconnected the fuses keeps blowing . i have a volt meter install and it reads 11.5 when car is running last electrical thing i did was install car audio amp

The fuse blows because you're drawing too much current. Putting a larger one in is only going to damage something or cause a fire. Stop doing that...


Chances are something went wrong with your install and you have a hot wire grounding out. That would be my first guess.



Whatever you did, undo it, and see what happens.

The battery should read more than 12 volts. When the alternator is working, it should read about 13.5 volts at the battery.

Yep, it sounds like you have a dead short in that circuit.

Did you install the amp? If so, like suggested, you may wish to check your work. If someone else installed the amp, I'd suggest you take it back to them and ask them to sort it out.

That ought to keep you busy tomorrow .. :confused0068:


humfrz

well everything i install i undid nothing is connected to anything in the amplifier or capacitor the battery is a yellow optima the car cranks and runs just no dash indication i have a push start and i click it first time and it turns on the radio and i click it again and i hear the fuse pop ..

What fuse exactly is it that keeps popping?

Well, OK. Which fuse keeps blowing, more importantly, what other accessories does that fuse control?


humfrz

This is going to be a PITA but either you need to check every cable coming from the cluster yourself or take it to a reputable shop that does it until you/they find the grounded cable.

Get a code reader and check for codes too, might be surprised and find something there

Im already a step ahead remove the gauge cluster disconnected and put fuse in and still pop im try code reader