|
Carbon driveshaft from DSS
4 Attachment(s)
Hi guys, I bought the dss carbon driveshaft from @R2RO, but my mech said it’s way too short, it’s about 7-8” short compared to oem. Is this normal ??
It measured 47” long and about 3.5” thick vs stock @ 55” long. When I checked out the current one on sale on the driveshaft shop, the part number is TOSH86-C compared to the one I have now as TOSH86-CF. |
Just going for the low hanging fruit but are you sure you have the right one for your transmission? ie not using one for the auto with the manual trans
|
Yup it’s for an MT and I do have a manual trans.
|
what did they say when you contacted them?
|
TOSH86 is for manual trans
TOSH87 is for auto trans So you have the correct part number for a manual. I would definitely check with DSS and see what they say the length should be. |
considering that is straight and not angled like the original maybe is normal
|
3 Attachment(s)
Nope it isn’t normal. I bought a brand new shaft from the DSS and it measured longer and thinner.
|
Mislabeled drive shaft sounds like. If I had a dollar for every time I received a mislabeled part, I could at the very least get a decent lunch.
|
| All times are GMT -4. The time now is 04:51 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
User Alert System provided by
Advanced User Tagging v3.3.0 (Lite) -
vBulletin Mods & Addons Copyright © 2025 DragonByte Technologies Ltd.