bumper install with splitter question
 

I recently one a free "splitter" on an instagram raffle. I installed it on my front bumber but it covers the holes to attach the liner underneath the car. I am also not able to get the fended flush at the corners and there is a gap between the side panel. My splitter is also somewhat tilted up. Is this all because the bottom liner is not attatched to the bumper correctly? If so whats the best way to attatch the liner to the bumper with the splitter?

The splitter will naturally be tilted upwards because of how the lower portion of the bumper is. Try putting the bumper on with the help of a friend, I found it fits much easier than doing it by yourself.

It would also help if you could post up some photos.

What type of splitter? There are many makes and models and not all go on the same.