|
BRZ STI tS DAYLINER Part Replica?
1 Attachment(s)
Does anyone know if there are Replicas or 3D printed versions anywhere for this part? I love the look of them but have a hard time justifying the price tag of 350-400 for two pieces of plastic...
Thanks in advance, Photo for reference: |
Before I destroyed my bumper this winter and went RB, I wanted to go for this look. Couldn’t justify the price tag either, but I was going create the same look using vinyl. That’s probably like $30 In vinyl tops and when it gets scuffed up from rocks you won’t feel as bad.
Sent from my iPhone using Tapatalk |
They cost $350-$400??? Da fuq.
|
Don't they usually need to put an STI badge on the part for a piece of plastic to be that expensive?
|
Sounds like they found out how TRD makes money. :)
|
Was wondering the same thing... would be nice to have a $20 replica of that. It shouldnt cost more than 20 -_-
|
Bump for a solution!
|
Quote:
|
1 Attachment(s)
|
bump
|
Sorry to revive this old thread but I came across this DIY for the 2015 tS dayliner
Site is in Italian: https://gt86brzclubitalia.forumcommu.../m/?t=58352547 Translated to English: https://translate.googleusercontent....bdzpnnG5OSzeOA |
Quote:
|
vinyl.
that's all i would do. most ebay stores sell pieces in about the size needed. here, a 1'x5' piece is $18. shipped. enough to make 2, and screw up 3, at least. https://www.ebay.com/itm/Genuine-3M-...K0RJ_luKu_fAtQ |
| All times are GMT -4. The time now is 08:40 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by
Advanced User Tagging v3.3.0 (Lite) -
vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.