Factory reverse lockout plate bolt specs?
 

Hey everyone,

I ordered an FT-86 Speedfactory short shifter and it seems like some people are having issues with the bottom of the reverse lockout colliding with the factory bolts holding the lockout plate to the carriage.

I know that Torque Solutions as well as Kartboy provide different bolts with their kit to mitigate any clearance issues; does anyone have the specs of these bolts so I can pick up a set before I proceed with the install?

Thanks!

My suggestion would be to bring a bolt to home depot and use their thread chart to verify. If you don't get a response on here that is.

That is the worst case scenario option but would work. If anyone knew however it would save me having to drive to Home Depot with half my interior apart :lol:

So, I've found the bolt in question if this helps.

Just need to find the specs of it.