Cruise Control switch brackets for use with aftermarket steering wheel
 

I had these water jetted out of 5052 1/8" thick aluminum, they work like a champ. If you need / want to keep your cruise control in reach and use an aftermarket wheel, you might want one. Not looking to make a dime here, just recoup a few bucks on them (minimum run was 5). I have 3 for sale, $25 all in PayPal, shipped USPS priority small flat rate box. Pm me if interested in one. Thanks! Joe V

I'm interested! Do you have a picture of this installed in the car?? Which bolt pattern is it for? Thanks!

The standard Momo/sparco/omp 6 bolt pattern. I'll work on getting a pic of it in the car this week for ya :)

hmm.. I'm gonna run a works bell hub/quick release with a nardi wheel..but I still think this will work with it, the WB hub seems to be momo/sparco pattern, and the QR is both so should be all good. DM me your paypal address and i'll shoot ya payment :)

Yes, that's the same pattern. I think it's 6 x 70mm? But it'll line up just fine. Pmd you my PayPal.

Here's a pic of one in my car, with the cruise switch stalk installed.

Jeremy R - your adapter is in the mail :). Two left, anyone else interested?

All sold. Please close thread ;)