data logging issues on ecutek. disconnection from obd
 

Hello, I recently installed a tune and am suppose to send some data logs back to the tuner. the tune is working, but unfortunately every time that i try to collect data, i get this disconnection error saying that it can't read obdii. the fuse is good. anybody else have this problem? i believe it may be my actual obd port, but i am not sure.

Make sure you have the same tune open in ecutek as is in the ecu

If you flashed tune ok the obd port was ok then

Try reducing the number of logged parameters

Dont stsrt logging untill engine running and stop and save log before tunring engine off else it will fail