Shifter Stuck
 

I just replaced my clutch to a stage 2. After getting everything done I shifted it into gear (Car off), and now it's stuck in gear. I had already replaced the clutch and put the transmissions back. The only thing I hadn't done yet was replace the trans oil before I shifted it.


Car starts and sounds normal. It will also roll with clutch out, but it is just stuck in whatever gear it is in.


Any ideas how I can get it unstuck? (preferably without removing the transmission again).

Disregard. Apparently you can just easily install your shifter backwards as you can forwards. It was just backwards! Easy fix, thank fkn goodness.

Lol nice

I was about to jump off a fkn cliff. Changing the clutch out was a huge pain in my ass cause I was too lazy to go buy a transmission jack, lol. I thought I fked it up! Thank god it runs and works and I'm just a stupid fkn ape brain, lol.

Did you change out the clutch fork, pivot ball, and throw out bearing?

Just some additional info for future people searching if you put your clutch disc in backwards same result. Cant change gears (while engine is running)