OEM Reverse Lockout Pin Stuck
 

Need some ideas...

Uninstalling the OEM Reverse Lockout. I used a 3/32 Punch and Hammer as per the procedure. With some firm taps, the pin came out the back slightly. Since then, no amount of hammering has moved it further. I grabbed the pin with a pair of pliers and attempted to remove it the rest of the way. No luck.

The pin will not budge in or out now. So, I am now stuck with the Pin a quarter of the way out.

Any ideas what to do at this point?

- Thanks

Maybe have a friend grab the other end with pliers and wiggle the pin while you try tapping it out again.

I found it to be a two man procedure. I held the shifter steady while the other person hammered the pin out. Otherwise too much of the impact energy is lost in the shifter moving around.

Its recommended you put the shifter into reverse while doing this so you dont have to line it back up later. I think that also takes some lateral pressure off the pin. Are you doing that?

I always held the shifter firmly in reverse (pushing the gear shifter forward) while holding the pin in place with the same hand. Then just give the pin some really hard taps.

I was using a rubber mallet too because I was scared of damage, but turns out the rubber absorbed too much force. So thats another thing to consider.

Yes, the shifter is in the Reverse position. I have held the pin and hammer in this fashion as well. I will keep at it.

I placed a covered 2x4 behind the shifter to restrict its motion. This allowed for firm applications with the hammer.

I swear to god that pin is pain in the ass to deal with.

Hi! new here first post :) Can you try locking vice grips on the exposed end of the pin, then use a screwdriver inbetween the vice grips, or in the vice grips and hammer the pin out. Think of it as pulling the pin, not pushing. Good luck

That pin i heard is 50/50 on keeping it. Some people drill it out, others have no problems. I haven't touched that part of my car yet, but i'll be buying a second pin before i do.

Sent from my HTC6535LVW using Tapatalk

I used pliers, and pulling the pliers towards you, turning the pliers around the actual lock out as leverage.....if that makes any sense


Sent from my iPhone using Tapatalk

UPDATE:

The pin would not budge. It appeared to be wedged somehow.

Gave up and took a dremel to the shift know. After cutting off the shift knob, the pin would still not come out.

Being left with half a pin stuck out, I slid the new lockout into place. I found a similar metal rod in the garage that I bent to fit. Once in place, I hammered it the rest of the way into the hole. VOIALA!

What you see is an entirely Macgyver built, brutally tested masterpiece. :thumbup:

https://s8.postimg.org/9f1mp8mwl/186...41291324_n.jpg
https://s24.postimg.org/5grwa732d/image.jpg

Doesn't truly work unless it can handle a burnout lol

Sent from my HTC6535LVW using Tapatalk