will this wheel and tire combo fit with stock suspension without rubbing?
 

hello guys i was looking to get some new rims and tires and i was wondering if this combo would work with stock suspension

18x9.5 +35

245/45r18

if anyone knows please let me know

thanks :)

u have to go with 245/35. it will fit without any issue. but it will poke out pass the fender in the front. unless you dial in negative camber with camber bolts

http://www.ft86club.com/forums/showthread.php?t=7535

Check this.

Probably shouldn't mess with camber too much with this setup, as you'll likely rub the spring.

yup, will probably rub the spring perch with more neg camber

You could run camber plates instead of gaining camber at the bottom of the strut. There are HVT non-raising plates for sale in the classifieds right now.

Camberplates often come with noticeable NVH issues. For me with stock shocks at high enough level to revert to stock (actually to group-n) top mounts. Though probably not an issue for someone in country with public roads of better state.

I'm running 8.5 same offset and there isnt even 2 fingers between rim and stock spring in the front. You could prob get away with it. I'm also running 255 rears without any issues, but only 225 in the front.


Sent from my LG-H831 using Tapatalk

Very similar specs to what you want http://www.ft86club.com/forums/showthread.php?t=118306

Sent from my LG-H831 using Tapatalk

https://tiresize.com/comparison/
If you run a 245/45/18 that's almost 10% more overall diameter compared to stock, which will quite noticeably hurt your acceleration.