Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB

Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB (https://www.ft86club.com/forums/index.php)
-   Engine, Exhaust, Transmission (https://www.ft86club.com/forums/forumdisplay.php?f=8)
-   -   Clutch Master cylinder - bleeder screw size? (https://www.ft86club.com/forums/showthread.php?t=117198)

Joesurf79 04-04-2017 12:51 PM
Clutch Master cylinder - bleeder screw size?
 
Looking to put a speed bleeder in place of the clutch master cylinder bleed screw. Anyone know the size off hand? I've found the question asked a few places but no answer yet.

Savvy Tofu 08-28-2017 04:49 AM
Pardon any misinformation or if this isn't of any assistance, but I just installed the Speed Bleeder SB7100S-SS into the SLAVE clutch cylinder attached to the top of the bell housing of the transmission. I'm using ATE Type 200 and so far so good! I went with the stainless steel model for added insurance.

N234 04-10-2018 01:58 PM
Any idea if this is the correct size bleeder after applying the clutch slave cylinder swap, as per the Ultramaroon DIY?

Sent from my SM-G930W8 using Tapatalk

SuperTom 12-28-2019 09:16 AM
Quote:
Originally Posted by Savvy Tofu (Post 2969255)
Pardon any misinformation or if this isn't of any assistance, but I just installed the Speed Bleeder SB7100S-SS into the SLAVE clutch cylinder attached to the top of the bell housing of the transmission. I'm using ATE Type 200 and so far so good! I went with the stainless steel model for added insurance.
Thanks for this just ordered that speed bleeder as I am switching over to Chase Bays clutch line


All times are GMT -4. The time now is 08:22 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.


Garage vBulletin Plugins by Drive Thru Online, Inc.