Pioneer nav head unit help
 

I'm trying to figure out how to wire my amp for my subwoofer now that I don't have a subwoofer pre out. I have a high low converter coming but I don't want to lose the factory amp for speakers

Sent from my XT1650 using Tapatalk

I'm no expert but I think you would just tap into your factory speaker wires at the factory amp (strip the positive and negative without cutting the wire, wrap your new wires around the stripped section, solder and tape). Then your new wires will run to your high/low converter and then the signal from the converter goes to the sub amp.
Hope that helps,
Eman

There's another thread on here that covers some of this called, "cheapest way to get better bass". It's just a couple down. Check it out, it will help.

Sent from my SM-G920F using Tapatalk