Troubleshooting Idle
 

Could a few of you that are smarter than me check out this video real quick and see if you see anything wrong with my vacuum lines? I've been trying to get my idle to stabilize but neither myself or my tuner can figure it out. Thanks!

[ame="https://www.youtube.com/watch?v=7yXebKBENB4"]https://www.youtube.com/watch?v=7yXebKBENB4[/ame]

Bump. Any help appreciated!

pull you intake off and clamp every hose. the hose that is just in front of you intake but next to your AC goes to a rail barb that heads back to you gas tank needs to be clamped as well. So if you see a line or don't see clamp it.

The wastegate lower port ideally needs to not be shared you vacuum lines but needs to go directly to the turbos compressor housing. you can add the boost control into the mix in-between the two. The BOV sharing vacuum lines can cause headaches.

had to go this route on the Turbo Busa and BRZ

yes the boost controller in this picture is manual but a EBC will work as well. If your compressor housing doesn't have a port or barb option, time to pull it off and tap it.

http://honda-tech.com/forums/attachm...bc-install.jpg

I think I'm already doing this. All hoses under the intake manifold are clamped and double checked. There are only two vacuum lines, one to the BOV and one to the EBC. The two other outputs from the EBC are to the compressor housing and to the wastegate.