Boxer 4 Emblem & Key Chain
 

I'm thinking of producing a boxer emblem and key chain. The example has the FT-86 logo which I’m not going to use in production due to copyright reasons. I’m still figuring out materials but the emblems will be available in different sizes and with different logos in the center.

For example:
· 2.0
· 2.5
· Japanese writing of 86.
· Boxer 4

Let me know if you guys like the idea and I’ll put them in production. I’ve had a prototype of the emblem made shown below.


http://home.comcast.net/~vr6gti/86/b...blem_small.jpg

Here are a few low res renderings of the car emblem and key chain.

http://home.comcast.net/~vr6gti/86/86emblem.jpg

http://home.comcast.net/~vr6gti/86/8..._key_chain.jpg

Depending on the final product, I'd probably be in for one. I keep losing my key in my ACU, I need something else attached to it

Sent from my Galaxy Nexus using Tapatalk 2

did you do those CAD designs off masterCAM?

Nice idea!

Here is my 86 keychains by the way

---> http://www.ft86club.com/forums/showthread.php?t=10046

Did you mill that or 3D print it? I keep waiting for something to upload some of these '86 designs to Ponoko...

It's 3D printed.

Put me down for two

its very poor printing resolution, id reccomend printing in a wax then mould & cast.
Companies like shapeways do printing like this and its cool to have something in solid from 3D design but not until they can print or mill to 0.005mm will i be wowed

Yeah, agreed, the place I mentioned (Ponoko) is pretty much the same as Shapeways in this regard.

Shapeways did the print.

Will it be something like this..?
All credit goess to @colHolm

heheh there you go. your drawing is perfect, your printer, not so much

That is the coolest keyring/keyrack I have ever seen, where did that come from?

See post:

http://www.ft86club.com/forums/showp...06&postcount=6