Alignment Specs?
 

anyone have the factory alignment specs for both FRS and BRZ?

most alignment shop still doesn't have them on their alignment rack

not even toyota!

care to share?


thanks!

Front:

Camber: 0 +/- 45' (0 +/- 0.75°) (Right/Left Difference: 0°45' (0.75°) or less)
Caster (Reference): 5°54' (5.90°)
Steering Axis Inclination (Reference): 15°31' (15.52°)
Toe (Each Wheel): 0°00' +/- 0°11' (0.00° +/- 0.19°)
Toe (Total): 0 +/- 3.0 mm (0 +/- 0.1181 in.)

Rear:

Camber: -1°12' +/- 45' (-1.20° +/- 0.75°) (Right/Left Difference: 45' (0.75°) or less)
Toe (Each Wheel): C + D: 0°10' +/- 0°15' (0.16° +/- 0.24°)
Toe (Total): 2.0 +/- 3.0 mm(0.0787 +/- 0.1181 in.)

Hope that helps.

Jeff

im assuming these are the same with the BRZ right?

That I'm not sure of, but I know I saw the BRZ RM PDF floating around a while back, I'm sure they'd be listed in there.

Jeff

thanks i ll need those this morning!

Where did you get this info... My Toyota dealer hasn't gotten the specs yet either... Just curious looks right to me

Every Toyota dealer has these specs, they're in the repair manual from Toyota, which every Toyota dealer accesses through TIS.

They probably mean their alignment machine software hasn't been updated with the information yet.

Jeff

Anybody have any recommendation for alignment setting for cars that see occasional track days?

Just go to any shop that performs alignments and have them perform a "before" reading. :)

stock Suspension???

My reccomendation:
zero toe front with as much camber as you can get...(put in the factory Crash bolts) that should render you about -1 degree or so..

Rear.. .1 toe in on each side.. camber for stock is about -.5 or so

Hope that helps...My BRZ has been on the rack about 4 times since I owned it..

Bill

here is the Factory alignment that My BRZ came with... kinda wonky if you ask me..


https://sphotos-b.xx.fbcdn.net/hphot...31304949_n.jpg

after a alignment check and adjustment..round 1...:) on stock suspension. the rear was adjusted to be even .1 toe in on each side..


https://sphotos-b.xx.fbcdn.net/hphot...03803971_n.jpg

To add to Jeff_Lange's post, here are the official FR-S alignment specs:

The shop I'm getting an alignment only has specs for the frs. Is that okay to use the frs specs on the brz?