TRD Rear Bumper Cutout Template
 

I spent the last 30min searching, but have found nothing of use.

I recently purchased a used TRD rear bumper diffuser and would like to install it myself. I understand that cutting of my stock bumper is required to fit the TRD piece.

If anyone has a template or know of where I can get one then I'd appreciate the help.

It's easy where do you live might be able to help

Sent from my SM-P600 using Tapatalk

I live out in Chino Hills, but I do come down to OC often. If you can help then I'd really appreciate it.

yeah definitely bring a short saw or short mechanical saw if you have if not I guess I can borrow one well cut and slap it on.
here's mines http://uploads.tapatalk-cdn.com/2016...ff7c615194.jpg

Nice!! Is that a Blitz quad tip exhaust?

Also would a dremel work? I don't have a mechanical saw.

Also I have the whole rear TRD bumper. Would that matter? I noticed you only have the exhaust garnish.

it's mxp sp quad burnt tip with TRD cutout

wait.. you got rid rear bumper with quad cutout?

No. What I meant was the TRD piece I have is the jdm lower half that goes onto the rear bumper.

Would the cuts be the the same as yours?

http://i40.photobucket.com/albums/e2...ps3ac71af0.jpg
Like that one.

a bit different we need to measure the outline of the diffuser exit than mark than cut a bit wider to hide cut line. after we start installing

Ok. Cool. I gotta order some 3m tape and some weather stripping. I'll hit you up when I'm ready. Thanks for the help.

sure

Where did you purchase this if you dont mind me asking? I have been trying to look into getting a trd rear bumper.

Sent from my SM-N920V using Tapatalk