|
Back to stock header - lost nuts
Got everything back on, then realized my openflash header used new bolts/nuts while the stock has studs for the overpipe/joint pipe. Can't find the 2 OEM nuts anywhere.
Online seems to think they are M10x1.25 nuts but can't confirm - the shop diagram doesn't show those 2 bolts. If someone has their stock header/bolts kicking around I'd be super grateful for a photo of one of the nuts (or the spec). Dealer closed tomorrow so home depot will have to do. |
1 Attachment(s)
Yes, M10 x 1.25
Thread OD is .393, close enough to M10 6 threads measure .294 inches = 7.4676mm / 6 = 1.2446 close enough to 1.25 Close enough for an analog caliper. It's all I had on my desk at the time. |
Thanks again - went to AutoValue and got 3 nuts for a buck. Worked perfectly, back up and running in 2 mins.
Will run for a heat cycle or two then retorque everything before putting the cover plates back on. |
Is the oft header a uel? Interested in selling it?
Sent from my iPhone using Tapatalk |
| All times are GMT -4. The time now is 02:52 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
User Alert System provided by
Advanced User Tagging v3.3.0 (Lite) -
vBulletin Mods & Addons Copyright © 2025 DragonByte Technologies Ltd.