Scion Radio Logo Removal
 

I just finished up my re-badging my frs. front and rear badge, steering wheel. The only one left for me was the scion logo on the radio trim piece. I attached some pics, the radio trim piece is not the best. I went to Autozone auto parts. I think Oreilys and Advance have them also. I used the narrow black pinstripe. They have 2 sizes the wide and the narrow. It was I believe about 6.00. I cut a smell piece it attaches perfectly to the trim. the size is perfect and covers the scion badge perfectly. It a pretty good grade of vinyl tape they use as its designed for pin stripping. I went ahead and covered the pioneer logo and cut the edge in a contour so it looks factory. If you do it and you don't like it you are out 5 or dollars. I think its a low cost and time saving alternative. best regards Steve

I did the same thing works great

Good deal partner Its just a pain to take out the radio, remove the front bezel I'm pretty sure a tab would break, the freakin bezel is probably 500.00 more than the radio, or you can only get it with a new radio, anyway hope this helps out somebody looking to save a little time. Steve