Rocket Bunny Photoshoot With TunerCult
 

Did a photoshoot with TunerCult yesterday, i think the photos turned out pretty good. Make sure you check them out on IG!

Car IG: Quiksiv
Publisher IG: TunerCult
Photographer IG: JDautomotive

http://i1108.photobucket.com/albums/...s4azsskts.jpeg

http://i1108.photobucket.com/albums/...sf5omyyz0.jpeg

http://i1108.photobucket.com/albums/...sla33n7wd.jpeg

http://i1108.photobucket.com/albums/...s6yvq3qz3.jpeg

http://i1108.photobucket.com/albums/...sryfi553l.jpeg

Technically not a build thread, but a nice photo shoot none the less! Love the wheel colour

i'm not able to read the words on the fender garnish so i'll have to shamefully ask, which brand are those?

Intec.

Nice car!
Would've liked to see more low, and more aggressiveness in the rear. But that's just me!

width or height?

Both?

Yeah i agree. Either theres too much camber or the forgetstars don't have enough offset. That front fitment is on point tho:clap:


But then again thats just me as well! :D Love everything else about the car.

Fitmet looks goofy in the rear. Nice look overall.

I was actually thinking the same thing, should i use spacers or could LCA's correct it?

Depends on if its too much camber or if you need to push out your wheels with some small spacers.

Give is a photo of the rear dead on so we can see the wheel angle. That should tell us everything we need.

If it is too much camber (which is my guess), a simple addition of adjustable LCA's will solve everything.

It doesn't seem like camber is the problem, to me.
I think spacers would work fine, or a lower offset for the wheels - but that's too late now, lol.

And lower your coilovers a bit in the rear, and that should be okay!