Invidia Q300 catback & Invidia catless front pipe: 2015 Subaru BRZ
 

https://youtu.be/3TgkzXGErJM

Sent from my ONE A2005 using Tapatalk

It sounds too stock from the inside...hopefully some borla uel headers will wake it up..

Sent from my ONE A2005 using Tapatalk

The Borla headers will make it much louder.

I have a catless front pipe/catted EL headers/overpipe/q300 and cold starts are ridiculously loud, under normal driving it's okay, but when I accelerate, you can hear it from the inside. It's not loud or annoying, but can be heard by everyone, if that makes sense

I would imagine it will make it louder. I was just surprised at how quiet it was when I installed my catless front pipe...

Sent from my ONE A2005 using Tapatalk

I have this exact setup, except my front pipe has a resonator. I like it... its throaty, but quiet enough that it doesn't attract unwanted attention. The tips of the Q300 look stock-ish but fit the rear end of the car perfectly.

Admittedly, the car is quiet. Sounds great in the car with the sound tube plugged. From the outside, it has a growl under WOT. The cold start high-idle sounds amazing.

Here's a video of JUST the cat-back (no front pipe yet). This was the first startup after the install. Ignore the fluttering noise. It went away within the first day.

[ame="https://www.youtube.com/watch?v=TwEQ6Q1SF-o"]Subaru BRZ Exhaust: Stock vs Invidia Q300 - YouTube[/ame]

I watched and commented on your video before I purchased my q300....your car looks good

Sent from my ONE A2005 using Tapatalk