Deep Dish Rims staggered stance
 

Does anyone have any links/pics of a deep dish rim on an FR-S? I've been looking around but haven't seen anything as of yet.

Also, what are you thoughts of having a staggered setup for the FR-S?

I'm looking for a staggered setup myself. Still searching for the right wheel and offset.

http://www.ft86club.com/forums/showthread.php?t=9330

This would be the widest i have seen so far.

9.5 +30 is the most aggressive ive seen.

I'm planning something like this. Work XD9s. 17s 7.5 +42 front/8.5 +32 rear. That is if I don't want to go custom PCD and get 18x8/18x9. Not much more out there in terms of lip that I have found.

Staggered will upset the dynamics of the vehicle.

But go ahead if you are just looking for "stance".

http://www.ft86club.com/forums/showthread.php?t=9309

My car on 3 piece SSRs. 18x9 +38.

Not much of a lip and not staggered. To fit anything wider you would need to run stretched tires and roll the fenders a bit.

How much do those rims weigh, Freed, and how much do you sell them for?

The SP1s are usually very light. I think an 18x9 should weigh in around 18-19 pounds, but don't quote me on that. They are very light even with tires.

We aren't an SSR dealer, I bought these off a WRX. Used set usually runs about $1500-2200. New around $3000-4000

this car can't take much "dish" as it runs higher offsets. Unless you plan on doing some body work or the whole hella flush thing, just can't happen.

WORK Meister S1R 18" weight around 23 lbs.

Assuming semi aggressive offset with stock caliper

18x9.0 +38 / 18x10 +38

Front lip size for WORK Meister S1R at 3"
Rear lip size for WORK Meister S1R at 3.8"

http://farm8.staticflickr.com/7196/6...b49ea12c_b.jpg

not this big, but just an idea ...

http://farm6.staticflickr.com/5464/7...02e4f4bb_b.jpg

Another possibility

http://farm8.staticflickr.com/7073/7...d7d994fd_b.jpg

Not going to happen, but what the heck , thread say deep dish

http://farm8.staticflickr.com/7036/6...c14b793e_b.jpg