Added E85. Ethanol Gauge didn't change?
Using Moto East's Flex fuel kit. I've been tuned for it as well. I added 11 gallons of E85 for the first time and started up my car. The car drives fine but my digital ethanol display gauge didn't change. Drove 2 miles home after that and it still didn't change.
Any suggestions? :/ |
Keep driving, it takes more than 2 miles
|
Quote:
|
Yea on my oft it takes almost 10 miles for my fuel trims so change.
|
Quote:
Sent from my GM1915 using Tapatalk |
The ethanol percent should start to change on guage in first few e of miles. Two might be a bit short but if you do 5 and nothing changes its a bit unusual
It may depemd on the port to direct injection ratio as you have to put your sensor in either the di or the port feed line. If your tune uses a lot of di down low put in di if it uses a lot of port put it in port line. If its rear 02 flex kit log the rear 02 sensor volts, close to 0 volts means zero ethanol, close to 5 v means close to 85% ethanol in most cases |
What is your ecutek log seeing?
Sent from my GM1915 using Tapatalk |
Quote:
Thanks all. |
All times are GMT -4. The time now is 08:02 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by
Advanced User Tagging v3.3.0 (Lite) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.