Ace and Nameless header comparison
Hello all,
I just switched from the Nameless header to the Ace and wanted to share my experience. This is on my STX prepped car, mods are identical between dynos other than the related front pipe/over pipe. Both tuned by Church via ecutek, same dynapack, runs are 2.5 years apart. CA 91 oct. Mods: TRD intake Perrin 2.5" resonated CBE Nameless setup: Early release tri-y header w/3" outlet Nameless 3" over/front pipe w/cat, resonator and helmholtz. Tapers to 2.5" at CBE. Ace setup: Type A 350 tri-y header and over pipe JDL 2.5" front pipe w/cat and resonator (ultra quiet) Green is Nameless, blue is Ace http://i.imgur.com/Q6VITKF.jpg |
So did this come out as you expected or...
|
In before it gets too hot in here :popcorn:
|
Quote:
|
Is that running 93 or e85?
|
Quote:
|
Quote:
|
Quote:
|
Thanks for posting this!
|
Quote:
|
I went from Nameless to Ace and never looked back.
Still had a big torque dip with the Namless from 3200-4400 or so. My Ace has a small dip from 2250-2750, but that's a low enough RPM that's it's not really noticeable (unless you're @Decay107 and looking for a reason to shit on my EL hawtness). edit: I'll add that tomei/gruppe-s is the way to go. I don't like UEL/bro sounds, so that's why I will forever be mocked for spending too much money for within-spitting-distance results). |
I'm shocked!
|
Quote:
|
Nice! I've been wanting to see a comparison between these two headers.
|
All times are GMT -4. The time now is 05:01 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by
Advanced User Tagging v3.3.0 (Lite) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.