Need Suggestion on How Much I Should Sell My Supercharged FRS
 

I am thinking to sell my 2013 FRS.
About 55k mile now, probably it is time to sell it.

I am located in New Jersey, and I did some research but did not found any FRS with similar mod for sale.

Not trying to part out.

All parts are top-level, including TE37SL, Sti Brembo, KW V3, Vortech SC, all exhaust from header to catback, craftsquare mirror(about $800）, all Alcantara interior panels, BRZ limited seats.
I spent close to $30k + the car value on it.

Will $23k sounds reasonable? including a set of winter wheels.

Can anyone suggest on the price?
I might only trust the suggestions from someone who is NOT looking for a used FRS now, hah.:popcorn:

Thank you!

Update:
I just found a car sold for about $30k with similar mod(a little cheaper) but much lower mileage (about 10k).
http://www.ft86club.com/forums/showthread.php?p=2266860


http://www.ft86club.com/forums/attac...1&d=1447080973
http://www.ft86club.com/forums/attac...1&d=1478095945
http://www.ft86club.com/forums/attac...1&d=1478095945
http://www.ft86club.com/forums/attac...1&d=1478095945
http://www.ft86club.com/forums/attac...1&d=1478095945
http://www.ft86club.com/forums/attac...1&d=1478095945
http://www.ft86club.com/forums/attac...1&d=1447080973
http://www.ft86club.com/forums/attac...1&d=1478025886
http://www.ft86club.com/forums/attac...1&d=1478025886
http://www.ft86club.com/forums/attac...1&d=1478025886
http://www.ft86club.com/forums/attac...1&d=1472578242





Here is my mod list:

POWER/ ENGINE/ UNDERHOOD DRESSUP
Vortech H/D V-2 H67B Supercharger Kit V3 @ Ultrarev
JDL UEL Catless Header - Black Ceramic Coat @ JDL Autodesign
JDL 2.5 Over Pipe - Black Ceramic Coat @ JDL Autodesign
JDL 2.5 Catted and Resonator Ultra Quiet Front Pipe @ JDL Autodesign
ARK GRIP Burnt Catback @ JM auto racing
Omni 3 Bar Map Sensor @ ft86speedfactory.com
P3cars OBD Gauge @ AZP Install
Password JDM Engine Bay Dress Up Kit - Gunmetal @ Amazon
Grimmspeed Hood Struts @ ft86speedfactory.com
TRD Fuel Cap @ ebay
Gates Higher Performance Belt (Not Installed) @ ft86speedfactory.com
Dimple Magnetic Oil Drain Plug @ ft86speedfactory.com
Raceseng Cam Plate @ ft86speedfactory.com
Radium Dual Oil Catch Can with Petcock Drain Kit @ Titanmotorsports


SUSPENSION/ DRIVETRAIN
KW V3 Coilovers @ ft86speedfactory.com
Vorshlag Front Top Mount @ evasive motorsports
Cusco Rear Lower Control Arms @ ft86speedfactory.com
Cusco Front Strut Bar @ autocityimports.com
Cusco Rear Strut Bar @ autocityimports.com
Cusco Engine Room Power Braces @ frsport.com
Cusco Quick Release Levers @ frsport.com
Cusco Accel Pedal @ frsport.com
Cusco Drift Button - Silver @ ft86speedfactory.com
STi Battery Tie Down @ ft86speedfactory.com
Perrin Rear Shifter Bushing @ ft86club user
Whiteline Toe Arms @ ft86speedfactory.com
Whiteline Sub-frame Bushing @ ft86club user
Whiteline Positive Shift Kit @ ft86club user
MTEC Shift Spring Kit @ ft86speedfactory.com



BRAKE
STI 08+ Brembo Calipers Front & Rear - Red Powder Coat @ nasioc user & needpowdercoat
Carbotech Bobcat 1521 Front and Rear @ knsbrakes.com
Stoptech SS Brake Lines Front&Rear @ knsbrakes.com
DBA 4000 T3 Slotted Rotors Front & Rear @ knsbrakes.com
GrimmSpeed Master Cylinder Brace @ ft86speedfactory.com



WHEEL
-Summer-
RAYS Volk Racing TE37SL Pressed Graphite 18X9.5 +40 Square @ prime motoring
Michelin Pilot Super Sport 265/35R18 @ tirerack.com
Project Kics R40 - Neon Chrome @ Nengun.com

-Winter-
XXR 527 Chrome Black 17x8.25 +25 Square @ TireCrazy.com
225/45R17 Michelin X-Ice Xi3 @ tirerack.com
STi Customized Center Caps @ ebay
Mcgard SplineDrive Chrome/Black w/ lock @ Amazon



EXTERIOR
Five-Axis 6-Piece Body Kit @ DCH Toyota Dealer
Craft Square Carbon Fiber Mirrors. @ evasive motorsports
TRD Aero Stabilizing Trunk Cover @ ft86speedfactory.com
Rexpeed Carbon Fiber Small Trim Cover @ ft86speedfactory.com
BRZ Fender Insert Swap @ ft86club user
JDM Window Visors @ ebay
JDM Toyota Badges Front @ ft86speedfactory.com
86 Piston emblem rear @ ebay
Tom's Shark Fin Antenna @ taobao.com
50% 3M Crystalline Tint Side and Back @ Auto Image



INTERIOR
Cusco Carbon Fiber & Leather D-Shape Steering Wheel @ pansontw
BRZ Limited Seats @ Local Seller
Defi Oil Pressure Gauge @ rallysportdirect.com
Defi Boost Gauge @ ft86club member
Block8Head Dual Gauge Pod @ Block8Head
JDM Frameless Mirror @ ft86speedfactory.com
3D Design Floor Mats @ ebay
TS Black Trims from Australia and Japan @ amayama.com
OLM Dry Carbon Fiber Key Cover @ ft86speedfactory.com
GT86 OEM Armrest @ ebay
GT86 Matte Black Steering Wheel Emblem @ ft86speedfactory.com
Volkswagen Hand Brake (Not Installed) @ Aliexpress.com
Genuine Alcantara Red Stitched 6mt Shift Boot @ JPM Coachworks
Genuine Alcantara Red Stitched Handbrake Boot @ JPM Coachworks
Genuine Alcantara Red Stitched Gauge Cluster Hood Assembly @ JPM Coachworks
Genuine Alcantara Red Stitched Knee Pads @ JPM Coachworks
Genuine Alcantara Red Stitched Speaker Trim Panels @ JPM Coachworks
Genuine Alcantara Red Stitched Bonded One-Piece Dash Panel Trims @ JPM Coachworks
Genuine Alcantara Center Console (DIY) @ Overland Designs
Canada Version Waterproof Trunk Cargo Liner @ kingswayparts.com
Toyota Auris/Aqua AC Vent (DIY) @ amayama.com



LIGHTING/ ELECTRONICS
Winjet Headlights - Black @ fteightysix.com
Tom's DOT Legal Red Tail Lights @ fteightysix.com
USDM OEM Fog Light Kit w/ Switch @ Carson Toyota
Optima Yellow Top Battery @ AutoZone
Diode Dynamics Dome/Trunk/Plate LEDs @ Diode Dynamics
Valenti Rear Bumper Fog Light - Clear @ Blackbeatmotor
Valenti Font Indicator Turning Signal - Smoke @ Blackbeatmotor
EuroR Advanced Ultra Slim Philips Ballasts @ hidpowerhouse.com
H7: Morimoto XB35 5000k HID Bulbs @ fteightysix.com
JDM Sti Clear Side Marker Lens @ ebay shipped from Japan

I would say it is very reasonable as it would not be possible to buy used and build to that spec for that price.

Thank you. Do you think is worth higher price?

I know it will cost about 10k to 11k to buy a 2013 FRS with that milage. And spend close to 20K on all used parts + $$ labor to build a car like this. But people keep telling me this kind of cars with lots of mods always devalue badly.

No driver-side floor mat, -10K.

There is 3D design floor mat. +10K.

It's a 2013 with 55k. All the rest would have to find a very specific buyer that likes your taste in modifications and wants to get involved with someone elses project car and the potential issues that come along with that. Especially with it being a 2013 and boosted. It looks well done and clean, but I think 23k might be optimistic.

Thank you! I will think over what you suggested.

Why are you selling it? All that time and effort out the window.

Hate to be a downer but I think you’d do good to get 15. You’d be better off parting out and going back stock.

IF you can find a buyer that wants what you have, $23k is a good asking price - I actually had $24k in mind before I read what you were thinking, assuming negotiation, and knowing I was probably being optimistic.

I'd guess $14k for the car without mods, again optimistic.

The trick, of course, is finding a buyer that wants what you've built. It's a nicely done build, so that may happen. And it may not.

They do. It doesn't matter how much you spent.
Looks like the normal asking price for a 13, with your mileage, around New Jersey, is $14K. Maybe get $5K for the mods if you are lucky so someplace around $18 to $20K is possible. Don't think you are far off in asking $23 but be prepared to drop that if you need to.

The one you linked that sold was 3 years ago when the value of the used ones was still fairly high and what he was selling was only a year old car. Yours is 5 years old and the value has dropped considerably.

And you have to assume that a car with that extensive list of mods was used hard.

There IS a picture with a helmet in the seat..

I was going to say that showing that is not a good selling point but figured I had passed on enough bad news. It is one thing to answer honestly if asked if the car had been tracked but something totally different to put it right out there.