2013 frs Turbo/built motor/flexfuel
 

Hello,

Thinking about parting ways with my FRS that I've owned for 6 years. Car is in excellent condition and meticulously kept inside and out. Only reason I am considering selling it is because I have picked up another project car and this car stays in the garage. I have driven the car 1k miles in the last year and a half.

2013 frs 52k miles/2nd owner/no accidents

Engine & Transmission:
Sbd500x Cerakoted hot parts in Tungsten color- installed @ 47k miles ~ 5k miles since install
Motor built at 45k miles
Cp pistons 10:1
Skunk2 Pro Connecting Rods
ARP Head Studs
King XP Performance Rod Bearing Set
GSC Beehive Performance Valve Springs
upgraded fuel pump/injectors
Zeitronix Flex fuel kit
Bluemoon baffle plate
KillerBee pick up tube
DSS carbon driveshaft
Perrin over pipe
Tanabe front pipe
Borla type s catback
Spec upgraded clutch
MAPerformance 19 row setrab cooler
mounted behind pass. fog cutout
Carbon fiber Catch can
futomoto drain valve
Dei and fire protective sleeve on coolant/oil lines

Exterior:
18x8.5 18x9.5 rota mx-r wheels wrapped in Pilot Super Sport 255/40 square
Front/side and rear lip
tinted rear taillight
smoked lower third light

Interior:
Custom carbon fiber and alcantara steering wheel
P3 vent gauge
Flexfuel gauge
manual boost gauge
In dash headunit with bluetooth/phone capability
Flossy weighted shift knob

Suspension:
Fortune auto 500 coilovers
SPC Lower rear control arms
performance alignment from agile performance in MD

I am probably forgetting a bunch of stuff, feel free to message me with any questions.

The car needs nothing. I repeat the car needs absolutely nothing. It is mint inside and out. Zero issues. No rubbing, creaking, clicking etc.

Motor was built and tuned on ecutek by Brady @ pure automotive perf. in Millersville, MD
Car made 300 whp on pump gas and 405 whp / 335wtq on full ethanol.
I usually run the car on a mixture which should be around 325-350 whp and it's plenty fast.

Asking price is $22k. NEW PRICE: $20k FIRM!!

Please keep your opinions to yourself if you do not like the price. I do not care. I will hold on to the car if I have to.. it is paid off!

If anyone is genuinely interested, please message me at 301-312-7535 as I do not visit this site very often.

Location: Laurel, MD

Not that bad of a price IMO given the low miles and forged internals - GLWS!

Why would you sell that? :confused:

Sent from my SM-G975U using Tapatalk

GLWS. Super clean car.

Sent from my GM1915 using Tapatalk

Thank you guys for the kind words.

I was recently offered $20k from an out of state person for the car which I eventually accepted but then the dude went no contact without even seeing the vehicle.
So, I figured I'd update the post with the new sale price I am willing to let the car go for.

The vehicle is currently only listed on ft86. I will eventually post it elsewhere for more exposure. Thank you.

Sale pending
 

SOLD!
 

SOLD!

Mods please remove. Thank you for letting me post.