Closed deck block, heads, head studs, rods, pistons, Edelbrock SC plus much more!
 

I'm preparing to do a V8 swap on my BRZ so all of these FA20 associated parts gotta go! All parts are very low miles. Most less than 1000 miles.

Here's what's left. All very high quality parts.

Edelbrock complete supercharger kit with less than 1000 miles on it!
$3600 shipped

SOUTH BEND CLUTCH STAGE 3 DAILY (400 FT/LBS) less than 1000 miles
$600 plus shipping

2016 Manual transmission with 17K miles
make me an offer prefer pick up

Ecutek tuning cable
$240 shipped

Closed deck block
ARP head studs
Carrillo CP pistons and rods 12.5:1
Stock heads



I will be pulling apart the FA20 in the weeks to come so all parts will be available!

Firm on your prices? Was looking at clutch and Perrin engine mounts

Yeah, I'm pretty firm on prices as everything is practically new. But feel free to PM me an offer. If things don't sell over time then I'll be more willing to negotiate.

Where in California are you located?

San Luis Obispo

Too bad for me you're not local to LA

Shipping within CA is pretty reasonable.

Do you have the whole oil cooler setup, or just the heat exchanger itself?

What version is the IRP shifter?

Yes, I have the lines, sandwich plate, the whole set up.

It is the V3 literally installed for only 48 hours. Loved the feel of it, requires some effort when shifting but it feels almost like a gated shifter when installed. No longer missed the shifter feel in my S2000 after installing this shifter. There will be some rattle at high rpm's though. I will include some sound deadening foam I purchased which was able to muffle 90% of the rattle free of charge to whoever buys. If you already have a loud exhaust or or drive with your windows down then the rattle shouldn't bother you too much.

Which version of the Flex Fuel Kit do you have?

MK1 which is the latest version as far as I know.

Are you selling the engine?