Gt86 1jz problems, help please
 

I'm new at this group guys i have a 2013 gt86

I fitted 1jz engine twin turbo the old engine.

But i have problems:

Rpm not working
Cruise control not working
ABS not working

Please advice or help me if you can.

did you shut it down and turn it on again?

Did all the sensors get put back in the right places and hooked up?

Did you set it to wumbo?

Rpm not working on the oem display/cluster?

If so, it won't work unless you're utilizing the frs crank sensor with a custom fabricated trigger for it to read from the jz crank. Even then chances are it'll be off from a true reading...

Cruise control--- lol

abs likely wont work until you have a "happy" crank signal

Willing to be they didn't hook up the factory ECU which has to be done. Bet they just used the 1j ECU to make it run but didn't realise you need to integrate the factory ECU to make all the other systems work.

Lol

From where can i get the fabricated triger ?

They tried to conect the factory ecu with the 1jz ecu, they couldn't.. Thre is a way to do that?

Its totally different sensor you cant connect then with the 1j

I'm pretty sure you have to or you need to run an aftermarket ECU like a Haltech elite. All the cars main systems run through the factory ECU, and if it isn't incorporated in some way nothing will work because it doesn't know it's running.

Is there any way you could contact Ekanoo in Bahrain? I'm sure he has a lot of information that could probably help you solve these small issues. Other than that you've got a lot more work to do.

Sounds like you're in way over your head. :thumbdown:

This is where I was headed with my question^^.
I knew they were different but wanted to see what the OP had to say about it. People need to do their research before they start the project not during or after.
Was sort of mean but:
http://s2.quickmeme.com/img/a7/a7eb1...1cf86f869c.jpg

This! try restarting it

While your at trying things.. maybe you could try putting this in the Engine Swaps section, you will probably get more help.

Sounds like the car is pretty much done and just needs a couple small things touched up on the electrical side.

Let's see what kind of knowledge you can bring to the table regarding this swap.....

None?

Didn't think so:thumbdown::thumbdown::thumbdown:

@Faris ali

I recommend posting in the engine swap section of the forum; you might get more traffic from people who will actually give useful information instead of the nonsense.

Also, I would recommend talking with @OmarGC as he has good experience with the JZ platform and these cars. I'd say to try contacting Ekanoo Racing in Bahrain, but theyy're not very active on this forum, so you might have to try to contact them through other means.