Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB
Page 927 of 977 « First 427827877917923924925926 927 928929930931937 Last »
Show 40 post(s) from this thread on one page

Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB (https://www.ft86club.com/forums/index.php)
-   Southern California (https://www.ft86club.com/forums/forumdisplay.php?f=10)
-   -   SOCAL: Local FS/FT (https://www.ft86club.com/forums/showthread.php?t=19346)

Thunder86 03-15-2020 01:32 PM
Quote:
Originally Posted by Thunder86 (Post 3287278)
WTS Work M.C.O. Racing Type CS 18x8.5 +38 (comes in Work “Blood Red”)

Wheels are wrapped in 245/35/18 Continental ExtremeContact DWS06

Set up will come with: OEM TPMS, Work license plate frames (2), Work M.C.O. wheel decal/sticker sheet, and a set of Kyo-ei Bull Lock Tuskey lug locks

Wheels were fully ceramic coated right out of the box. Wheels & tires have about 16k miles on them. Condition is 8/10 due to daily driving rash, however, they have never been curbed, tracked, autocrossed, etc.

Ran these with stock struts + TRD springs with -1.7 camber front and -1.5 camber rear... had ZERO rubbing issues and fitment is flush!

Links: https://www.ft86speedfactory.com/wor...l#.XgxZNySIaEc ... https://m.tirerack.com/tires/tires.j...06XL&tab=Sizes

This setup would cost about $2800 new. Would like to sell full kit for $1600 obo.

Local pick-up only for now.
Huge price drop! PM me with reasonable offers too!

degozaru 03-15-2020 05:01 PM
Quote:
Originally Posted by MugsBRZ (Post 3308874)
Hi All,

Going back to stock and need the parts listed below for a 2012-16 BRZ. I assume FR-S parts would work fine, too. I'm looking for parts in good condition with 30k miles or less on them. I also have a lot of aftermarket parts that I would be willing to trade or I will pay cash. I would meet you or pay for shipping.
Thanks,
Daniel

interested in the sun shade and the trunk organizer, but where in cali are you

EdBoy 03-16-2020 04:27 AM
Quote:
Originally Posted by MugsBRZ (Post 3308874)
Hi All,

Going back to stock and need the parts listed below for a 2012-16 BRZ. I assume FR-S parts would work fine, too. I'm looking for parts in good condition with 30k miles or less on them. I also have a lot of aftermarket parts that I would be willing to trade or I will pay cash. I would meet you or pay for shipping.

Thanks,
Daniel
Sent you a pm, I have quite a few stock parts laying around I need to get rid of.

Quote:
Originally Posted by stlgrym3 (Post 3308904)
RCE Yellow springs, ecutek cable & dongle, SPC rear LCAs for sale in temple city area. All in near new condition.

http://http://www.ft86club.com/forum...d.php?t=139300

http://http://www.ft86club.com/forum...d.php?t=139406

http://http://www.ft86club.com/forum...d.php?t=139407
Can't see the thread, but how much for the springs?

stlgrym3 03-16-2020 11:29 AM
Quote:
Originally Posted by EdBoy (Post 3309232)
Sent you a pm, I have quite a few stock parts laying around I need to get rid of.



Can't see the thread, but how much for the springs?
$180 for the springs.

zAnSh1n 03-18-2020 01:10 AM
Racer X Ball Joints
 
2 Attachment(s)
Brand new.

Front LCA ball joints: 020410 [gray]
https://racerxfabrication.com/frs-br...er-ball-joints

$120

MJones_RB 03-18-2020 02:58 PM
Quote:
Originally Posted by zAnSh1n (Post 3309862)
Brand new, unopened boxes.
Bought them years ago, but ended up going the 'show' route instead.

Front: PSP-SUS-131 [22mm]
https://www.perrin.com/shop/suspensi...-front-swaybar


Rear: PSP-SUS-230 [19mm]
https://www.perrin.com/shop/suspensi...z-rear-swaybar


$250/set


---

Rear end links: 020406 [gray]
https://racerxfabrication.com/frs-br...rear-end-links


$60


---


Front LCA ball joints: 020410 [gray]
https://racerxfabrication.com/frs-br...er-ball-joints


$120
Nice deal!

shiumai 03-22-2020 04:26 PM
P3 Cars OBD2 Vent Gauge for sale
 
P3 Car OBD2 Vent Gauge for sale - $290 shipped (MSRP $389) paypal or venmo. Or, local pick up in North Redondo Beach (Los Angeles area).


http://www.p3cars.com/subaru/p3-v3-o...uge-2013-2019/
P3 Vent Gauge Readouts (all readouts can be individually configured to read in either Imperial or Metric units)

  • Boost (through OBD2 port using OEM sensors or with P3 analog boost sensor)
  • Engine oil temperature
  • Coolant temperature
  • Air/Fuel ratio (can be read in AFR or Lambda)
  • Vehicle speed (can be calibrated in 1% increments from -9% to +20%)
  • Intake air temperature
  • Throttle angle
  • Ignition timing
  • Engine RPM
  • Exhaust gas temperature
  • Battery voltage
  • Programmable shift light
  • Analog input 1 (brown wire) can allow gauge to read any 0-5 volt linear output sensor
  • Analog input 2 (blue wire) can allow gauge to read any 0-5 volt linear output sensor
  • Acceleration timers (0-60mph/0-100mph/60-130mph)

Plug and Play - Easy installation into vent, then plug directly into OBD2 port under dash:
http://www.p3cars.com/content/pdf/brz-vent.pdf


https://i.imgur.com/Zm6NErg.jpg


https://i.imgur.com/qVShUKB.jpg

youngdriver94 03-22-2020 10:49 PM
STOCK SCION FRS WHEELS AND TIRES, SD/IE, $300
 
4 Attachment(s)
Stock wheels and tires from my 2016 scion frs. Just cleaned them up and put a coating of Chemical Guys Max Coat Wheel Guard on them. You can see in the pictures that they are in great condition and shining like new! Slight curb rash on some of the wheels but not too noticeable due to their color. I took these wheels off my car over 2 years ago when I got aftermarket wheels and they have been sitting in my garage ever since.

$300

I am located in San Diego but frequent the Inland Empire area as well, so I am willing to meet up in either area.

SOLD

youngdriver94 03-22-2020 11:05 PM
SCION FRS Stock Headlights, SD/IE, $200
 
5 Attachment(s)
Stock headlights from my 2016 scion frs. Bulbs and everything still work. They were taken off my car over 2 years ago and have been sitting in boxes ever since. During their time on my car it was always garaged so there is no hazing, yellowing, condensation, or peeling. They are in great condition!

$200

I am located in San Diego but frequent the Inland Empire so I can meet up in either area.

Sold. Please Remove

DarkSideFRS 03-23-2020 09:31 PM
Looking for rear bumper in 37j.. let me know what u have

FRS Johnny 03-25-2020 06:24 PM
Looking for a complete engine. Mine blew up :/

Rmikey009 03-26-2020 11:51 PM
Parts Sale
 
What's up everyone? I have a few used parts for sale that came with my '13 BRZ:


1) JDL UEL header - $600 O.B.O
2) A set of oem wheels 17 in'. Wheels come with tires, but the tires are pretty worn. $250 O.B.O
3) OEM exhaust - $150 O.B.O


I've been having trouble uploading any pictures so please feel free to text me for pix of the parts that you're interested in. 562-332-4740. Parts are located in Whittier, Ca 90603. My name is Mike. Thanks everyone!
:thanks::cheers:

Huevo_blanco 03-28-2020 01:12 AM
For sale
Location : Long Beach Ca 90802
Selling - FR-s bayson R ST-style front lip and bayson R Cs- side splitters both used 8/10 no cracks nothing is broken
Please pm and I’ll sent you pictures
Price : SOLD each or take both for SOLD

John Rambo 03-28-2020 08:42 PM
1 Attachment(s)
For Sale: KW v3 coilovers. I am the second owner. They have been in my garage for a while and I want them gone. Asking $750.

Local pickup in los angeles strongly preferred


All times are GMT -4. The time now is 03:13 AM.
Page 927 of 977 « First 427827877917923924925926 927 928929930931937 Last »
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.


Garage vBulletin Plugins by Drive Thru Online, Inc.