Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB

Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB (https://www.ft86club.com/forums/index.php)
-   DIY (Do-It-Yourself) Guides (https://www.ft86club.com/forums/forumdisplay.php?f=43)
-   -   Smoking or Redding BRZ/FR-S Tail Lights (https://www.ft86club.com/forums/showthread.php?t=7826)

DarrenDriven 07-06-2012 08:51 PM

Looks really good.

Lonewolf 07-06-2012 09:46 PM

Enigmus-You've cleaned up the rear of the car nicely. Any plans for the radio antenna?

Enigmus 07-06-2012 10:40 PM

Quote:

Originally Posted by Lonewolf (Post 300621)
Enigmus-You've cleaned up the rear of the car nicely. Any plans for the radio antenna?

thanks! actually yes i was going to start another thread about aftermarket antennas. I'm not a huge fan of the shark fin at all. I'd like it a little more low profile like the GTR antenna

http://www.lastonehere.com/misc2012/roof.jpg

if not i'd like to delete the antenna on the roof altogether and move it inside. Like how the viper alarm antennas are concealed and mounted to the glass
http://www.lastonehere.com/misc2012/alarmantenna.jpg
http://www.lastonehere.com/misc2012/antenna.jpg

Lonewolf 07-06-2012 11:51 PM

The in-glass antenna is something that I wish the factory did...who gives a crap about a slight drop in reception?

I just have a feeling that a workable antenna delete solution will be expensive and time-consuming. Please keep us updated!

Ichito240 07-16-2012 10:51 AM

After seeing the red, I was convinced because the black tint just meet really worked for me. But the red with black that you managed to pull off(even though you say you aren't happy with it) has got to be my favorite look so far. This will definitely be done to whichever model I end up getting and no matter what color I happen to get.

Thanks for the DIY instructions.

kidgogeta 07-16-2012 01:44 PM

How is the premium autostyling tint? I got mine done from a local shop and if you come up close you can tell its vinyl

Drvortex 07-16-2012 10:11 PM

Quote:

Originally Posted by Enigmus (Post 300547)

I took the risk and painted it myself.

Process
Prep clean Mineral spirits with nitrile gloves
3 light layers VHT NiteShade Red
3 passes heat gun in between each layer
1 Heavy layer VHT Niteshade RED
Wet sand 1500
Wet sand 2000
5 layers Krylon clear coat
3 passes heat gun in between each layer
2 heavy layers clear coat
Dry for 24 hours
Wetsand 2000 grit
Hand polish rubbing compound
Wax

tip: if you find specks of dust in between layers. do not touch it. let it dry a little bit more and with passes of the heat gun. then use Masking tape to pick off any specks of dust before proceeding to spray more layers.

I might remove the wax and polish it with a portercable as i don't feel it is glossy enough. if all else fails I'll bring it to a shop for a coat of clear coat.

Hey man, nice ride. You got your ride from New Orleans...that is great. I got mine there as well. Mine was the first one in but I ordered my third...got lucky. I ordered the blue limited and it arrived on 1 June. I picked up the next day and couldn't wait. I can't remember the sales person but I spoke w/ Rex about it. Do you think the dealership will work w/ us on any aftermarket stuff? Are you from N.O. then? I'm here in Gautier, MS...I work at Keesler AFB. Nice to meet you and being close by. BTW...when is the next track day at NOLA? I'm going to Grand Bay, AL on Saturday and test her out. Anyway, send me a message sometime and we can maybe meet up in NO on a wkend or track day. Laterz.

Jason

Lawnik 07-22-2012 01:55 PM

Thanks for the DIY
 
10 Attachment(s)
Followed it with the results below. I did smoked outside, with a red with smoke in the center. This is my attempt at FRS concept-like tails.

Could be clearer, but happy with them. Might try to add some coats of clear.

MmmHamSandwich 07-22-2012 02:17 PM

Quote:

Originally Posted by Lawnik (Post 331488)
Followed it with the results below. I did smoked outside, with a red with smoke in the center. This is my attempt at FRS concept-like tails.

Could be clearer, but happy with them. Might try to add some coats of clear.

Man I hate to be a **** but you've made your car a very neutral color that is easy to lose in many environments and lighting conditions, a finish that is very flat and non reflective, you've smoked/tinted your primary and third brake lights to the point their output is surely very diminished, and you've essentially neutralized all retroreflectors on the rear of the vehicle.

I've seen many people get seriously f'ed up due to high speed rear end collisions which you are now at greater risk for, stationary or otherwise. If you ever have to pull the car to the side of the highway, put your flashers on and abandon it until a wrecker or motorist assists arrives. I'm dead serious. Based on the wrecks I've been to it's a good idea in general and with a car like that pretty much a requirement.

Lawnik 07-22-2012 02:48 PM

Quote:

Originally Posted by MmmHamSandwich (Post 331517)
Man I hate to be a **** but you've made your car a very neutral color that is easy to lose in many environments and lighting conditions, a finish that is very flat and non reflective, you've smoked/tinted your primary and third brake lights to the point their output is surely very diminished, and you've essentially neutralized all retroreflectors on the rear of the vehicle.

I've seen many people get seriously f'ed up due to high speed rear end collisions which you are now at greater risk for, stationary or otherwise. If you ever have to pull the car to the side of the highway, put your flashers on and abandon it until a wrecker or motorist assists arrives. I'm dead serious. Based on the wrecks I've been to it's a good idea in general and with a car like that pretty much a requirement.

Wouldn't call you anything, it's just an opinion and thanks for it. Side reflectors yes I do agree were compromised, but the rest is just fine. Easy to see day or night, the tails are no darker than the last blazers or grand prixs.

Im wiring the forth brake light today.

I appreciate the concern, and so does my mother. lol:sigh:

Snoopyalien24 07-22-2012 05:05 PM

All these look great but if I were to red out the tails, I would do it like this chop I did:

http://www.imgur.com/Qg27U.jpeg

Or my preffered method of a blacked out housing like so:

http://www.imgur.com/KQ5zC.jpeg

http://www.imgur.com/hRlL1.jpeg

_hollywood 07-22-2012 11:15 PM

Damn the lights above are sick, i hope a respectable company makes a black chrome tinted taillight or even the red/clear version you chopped....i just dont want to do it myself and get condensation or drips, etc....

Erroneous 07-25-2012 11:07 PM

Gonna give this a shot within the next week, and will try to post pics. I'll mostly be following the Enigmus approach.

Erroneous 07-30-2012 12:17 PM

I apologize for the crappy picture (phone), but here's the finished product. I'll try to post more later.

http://oi50.tinypic.com/1zdljsz.jpg

Notes:

I apparently suck at painting, so there are some blemishes and irregularities on the tails. I still think it looks much better than stock, but I think if a manufacturer decided to make them. I'd definitely purchase a set.


All times are GMT -4. The time now is 09:27 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.


Garage vBulletin Plugins by Drive Thru Online, Inc.