Here the addresses dump for B01D:

Right on :D

What data are you generating these from? I can infer some of the info from what others have posted, but is there a document that shows the data types and units of measure of each address?

have a look at some of the logcfg.txt files and substitute in the ram addresses from your rom the scaling datatype should be same its generally just the ram address that changes. the names of ram address location may not be eaxactly the same sometimes it a bit of trial and error

unfortunatly no doco, if you find some post it up :D

That's why we need to get these into standard notation sooner rather than later - your best bet is the logger.xml file from the Romraider Logger, combined with a look through the other logcfg.txt files users have put out there.

..

I have version 1.59 OTS maps for OFT with the latest rom file listed as B01C. That means that all files are B01C calID? Also has anyone tried to log a ECUTEK tune with OP2?

I have version 1.59 OTS maps for OFT with the latest rom file listed as B01C. That means that all files are B01C calID?

NO !!! it does not you have to check with hex editor. or check table integrity. see first post.

Also has anyone tried to log a ECUTEK tune with OP2?

It should work if you match the RAM addresses with the tune calid, have not done it though. I believe they just change seed keys to prevent reading/writing of rom but RAM addresses for log parameters are likely the same.

I am getting close to figuring out logging with the tactrix OP2 but I keep getting a logcfg.out file and red with flashing green lights. Any ideas?

Ha I got it. It was the Triggers. I remove the defrost trigger and it work. Steve99 also said he had a problem with the defrost trigger. Any one else have a trigger that works well I could use.

I couldn't get any triggers to work so I just plug mine in when I want to log and pull it out when I'm done (lol). Much easier with an obd2 extension cable.

Can you post the order you used to get the triggers to work. I am not sure i follow the numeric order.

Again, I'm not sure if this will work all the time, maybe it just happened to work for me.

so let's say you have:
----------------------
paramname = Manifold_Relative_Pressure
paramid = 0xFFF88F78
isfloat = 1

paramname = Direct_Ijector_PW
paramid = 0xFFF887E8
isfloat = 1

paramname = Direct_Injector_PW_Ram
paramid = 0xFFF887F0
isfloat = 1

The memory addresses above in bold are numbers, so sorted numerically in asc order would be:
-----------------------
paramname = Direct_Ijector_PW
paramid = 0xFFF887E8
isfloat = 1

paramname = Direct_Injector_PW_Ram
paramid = 0xFFF887F0
isfloat = 1

paramname = Manifold_Relative_Pressure
paramid = 0xFFF88F78
isfloat = 1

Did you mix the triggers in with the rest or leave them at the bottom?

pmed