Originally Posted by Td-d (Post 1837791)

Try this:

FFF8DBD0 Ram_Fuel_Air_Commanded

Originally Posted by D-VO (Post 1840439)

@Td-d: Do you have the paramid for logging AFR commanded on the B01C ROM?

Originally Posted by mad_sb (Post 2070819)

Does anyone have the address for cruise control on / off for ZA1JA00C?

I have logging working without any triggers using some of the configs from: Tactrix EcuFlash Info for BRZ 86 Rom flash and logging

But I'm not having any luck triggering with defog.

Originally Posted by Toyota John (Post 2071119)

What are the code differences between logging A01C and B01C?

Originally Posted by steve99 (Post 2070832)

I have found that the triggers are very hit and miss, very often dont work at all, i have given up on them even trying to use coolant temp or rpm was no good.

suspect their is some issue with op2 code..
@Td-d might be able to hel but hes is on holidays, or the taxtrix guys


i think @vgi may have it working

Originally Posted by vgi (Post 2076287)

to be on a safe side i would rather suggest people use plane ASCII (ANSI) mode for their files. I don't know for sure but considering standard C/C++ reads/writes ASCII text file by default I doubt there was an effort made to actually support a full UTF8 character set supported.

ASCII is a subset of UTF8 (UTF8 was designed for backward compatibility with ASCII) so it's possible all the chars in your file were just ASCII. If any true UTF8 characters will be in your file I guess it may or may not work.

Also, many editors have a default encoding, you should check what that is. Many editors make an attempt to auto-detect encoding and if they detect some UTF8 characters they may place BOM in the file (BOM is a sequence of bytes (EF BB BF) that allows the reader to identify the file as an UTF-8 file). Windows notepad should be safe to use as default encoding is ASCII unless it detects UTF8 chars, then it will place BOM in the file. It also puts /r/n for new line instead of just unix /n, but it think it should be safe.

Originally Posted by [Ron] (Post 2187953)

I tried using your log config on my A01C ROM, however I seem to be getting invalid values (ie. RPM is logged as "1" the entire drive). I also need to remove the defogger switch condition to get logging working. I've uploaded my datalog here:

http://datazap.me/u/slowbaru/93-octa...5-6-9-16-22-24

I am using the OFT Stage 1 93 octane OTS A10C ROM. If this is based off the B01C ROM, is it possible I have different memory addresses? Does anyone have information on how to verify the correct memory addresses to throw in to the log config file?

@Td-d @d1ck @steve99 Any one of you have ideas? Thank you!

Edit-


I tried using @AdrianG 's log config but I am still getting incorrect values. If someone could provide some info on how to verify the correct memory addresses it would be appreciated.