Thanks. Only added the rear bumper wing things. Planning a few more things before I focus on performance but that's the idea to keep the car simple and clean.

Tinted the windows last night

What are the specs on your rims and tires?

Sent from my XT1650 using Tapatalk

What make and level of tints? Any pictures?

17x8.5 +35 215/45

:eyebulge:

Damn, Simplicity man. Looks sexy haha.

The damn flasher relay is a pain.... but,got to say, it was worth it, installed my new tail lights today 😘😍

I just drained the oil, moved the oil cooler in preparation for turbo kit install, looked at the clutch kit and thought to myself "f*** I need a hoist!" then went back inside.

SCUV

Sent from my SM-N900T using Tapatalk

Drained the fuel tank a little more

Sent from my SM-G935V using Tapatalk

Didnt do much to my car today but i saw this beautiful twin at the FIU campus last night http://uploads.tapatalk-cdn.com/2016...8a49f5c2ce.jpg if you own this car and see this i will be sending you my hospital bills for my neck!


Sent from my iPhone using Tapatalk

Noticed a burnt/melted spot in the middle of the of the rear seat cushion.
It's going to annoy me until I replace it.

Got a rock stuck in the left front brake caliper.
Bang! Squeeeee!

Had just pulled out of my driveway, so turned around, stuck the nose into the garage and pulled the wheel and caliper.

A small chip got stuck behind one of the shims and was bearing on the outer diameter of the disk.
No damage to the surface luckily.

Now, what are the torque numbers to put the bolts back in?
Spent an hour or more trolling through the repair manuals. Both the FR-S and BRZ manuals I got here.
The FR-S manual has no index. Couldn't find it paging through.
At least the BRZ manual has an index, but no torque numbers anywhere near the caliper entries.

Had to log in here to find specs in the DIY section. DIY: 86 Tightening Torque Values

Spent more time digging up specs than doing the job.

Also, got another rock chip in the windshield fixed last week. Covered free by insurance.

Reminds me of a RX-8, in a good way.