Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB

		Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Search Results

Showing results 1 to 4 of 4
Search took 1.02 seconds. Search: Posts Made By: Asian

Forum: Engine, Exhaust, Transmission

12-29-2017, 04:24 PM

Replies: 17

Welding an Exhaust Cutout

Views: 7,366

Posted By BirdTRD

I had a QTP cutout installed when I did 2.5 inch...

I had a QTP cutout installed when I did 2.5 inch from the overpipe back. The shop had a hard time finding a good spot to put it, they ended up right where the gap between the floor pan and gas tank...

Forum: Engine, Exhaust, Transmission

12-27-2017, 03:48 PM

Replies: 17

Welding an Exhaust Cutout

Views: 7,366

Posted By mav1178

If a muffler shop can't weld 2.25" or 2.5" to...

If a muffler shop can't weld 2.25" or 2.5" to your 60mm front pipe, they don't deserve your business.

Any muffler shop would have reducer adapters to make it work.

Forum: DIY (Do-It-Yourself) Guides

11-27-2016, 07:34 AM

Replies: 217

DIY Clutch Replacement

Views: 220,049

Posted By catsspat

Torque values.

I just went through the process last weekend (took 2 full days by myself), so, in case it helps anyone...

All values are from 2013 BRZ service manual.

* Under Cover (front-section -- aluminum)....

Forum: DIY (Do-It-Yourself) Guides

06-28-2015, 12:49 PM

Replies: 57

DIY Request: install Oil Pressure & Temperature gauge

Views: 40,018

Posted By dustmann

DIY Request: install Oil Pressure & Temperature gauge

I have the exact same gauge mounted in my car. I'm using one of the block8head defrost vent dual pods. See here: http://www.ft86club.com/forums/showthread.php?t=66333

As for the installation, I...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 09:48 AM.

User Name		Remember Me?
Password