follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 34
Search took 0.75 seconds.
Search: Posts Made By: VABeachBRZ
Forum: Mid-Atlantic 10-08-2017, 11:06 AM
Replies: 1,997
Views: 476,426
Posted By tian105
Your phone number is missing a digit Sent...

Your phone number is missing a digit


Sent from my iPhone using Tapatalk
Forum: Mid-Atlantic 09-29-2017, 02:18 PM
Replies: 11
Views: 3,221
Posted By SpectreRT
Both kits are great. Go to the owners...

Both kits are great.

Go to the owners topics and read up. :)

In Fairfax, VA - I know of a few local kits. People will likely take you up on the beer for ride offer.
Forum: Software Tuning 07-17-2017, 12:22 AM
Replies: 4
Views: 4,149
Posted By steve99
How Ethanol Flex Kits and Sensors Work E85

How Ethanol Flex Kits and Sensors Work E85


E85 - supposedly 85% ethanol and 15% petrol, but content can vary in places from E50-E90 and between summer and winter blends

Flex Fuel - often...
Forum: Forced Induction 05-14-2017, 12:25 AM
Replies: 36
Views: 13,728
Posted By CSG Mike
There is no "faster spool". A supercharger is...

There is no "faster spool". A supercharger is belt driven. It is always spooled. The C30 revs higher at a given engine RPM, because it has to spin faster to create a similar level of flow,...
Forum: Forced Induction 05-07-2017, 02:00 PM
Replies: 36
Views: 13,728
Posted By Freeman
Did you check the owners thread?

Did you check the owners thread?
Forum: Forced Induction 02-27-2017, 11:26 AM
Replies: 41
Views: 15,167
Posted By SooNomi
VeganGirl, I just remembered that in early...

VeganGirl,

I just remembered that in early January, you started a thread about the CEL that came up on your boyfriend's Kraftwerks FR-S (http://www.ft86club.com/forums/showthread.php?t=114312)

...
Forum: Engine, Exhaust, Transmission 01-25-2017, 08:11 PM
Replies: 33
Views: 7,927
The marginal increase in pedal pressure and...

The marginal increase in pedal pressure and improved response with the ACT kits are fine with us. The factory clutch kit is actually quite good. Improving one's driving habits and skills improves...
Forum: Engine, Exhaust, Transmission 01-25-2017, 05:28 PM
Replies: 33
Views: 7,927
Posted By Cybmx
I have this similar issue with the...

I have this similar issue with the clutch/flywheel. When the car is cold, everything is prefect, but after a long drive over 30mins the take-off will get really jerky and shaky. Once the car is...
Forum: Engine, Exhaust, Transmission 01-25-2017, 01:48 PM
Replies: 33
Views: 7,927
The combination of boost, lighter flywheel, and...

The combination of boost, lighter flywheel, and drive by wire always has a small lag at first startup generally from stop in 1st gear. Sometimes a similar feeling is experienced during downshift...
Forum: Engine, Exhaust, Transmission 01-25-2017, 12:06 PM
Replies: 33
Views: 7,927
Posted By BRZ FTW
Was the flywheel re-surfaced? This could cause...

Was the flywheel re-surfaced? This could cause the "stutter/buck/feel".
Forum: Engine, Exhaust, Transmission 01-24-2017, 09:42 PM
Replies: 33
Views: 7,927
Lighter weight flywheel plus drive by wire.

Lighter weight flywheel plus drive by wire.
Forum: Engine, Exhaust, Transmission 01-24-2017, 09:13 PM
Replies: 33
Views: 7,927
Posted By dp1
Usually takes 2-3k miles to break in clutch. I...

Usually takes 2-3k miles to break in clutch. I have the same model and it has similar behavior, more so when warmed up and only noticeable when moving from stop. Add gas and don't ride the clutch. ...
Forum: Engine, Exhaust, Bolt-Ons 01-20-2017, 11:29 PM
Replies: 2
Views: 725
Posted By prj3ctm4yh3m
sold

sold
Forum: Forced Induction 12-08-2016, 04:50 AM
Replies: 6,004
Views: 2,036,941
Posted By indy
Blower replaced under warranty. Broken blower...

Blower replaced under warranty.
Broken blower sent to the factory in Denmark, next month received a new together with the liquid and the new expansion tank.

Oscar Jr., thank you for your support!
Forum: Forced Induction 11-17-2016, 05:33 PM
Replies: 75
Views: 24,431
Posted By CSG Mike
Fact: I see more JRSC at the track than any other...

Fact: I see more JRSC at the track than any other centrifugals.
Fact: I see less JRSC failures at the track than any other centrifugals.

:)

At the 86 Showdown 2 days ago, there were more JRSC...
Forum: Forced Induction 11-09-2016, 01:07 AM
Replies: 15
Views: 3,744
Posted By BRZ'13
whats the point of the supercharger if you do not...

whats the point of the supercharger if you do not plan on driving it hard? better off saving the money and keeping it stock.
Forum: Forced Induction 10-31-2016, 07:07 PM
Replies: 6,004
Views: 2,036,941
Posted By JDMChris
A big advantage is the JRSC's air to air...

A big advantage is the JRSC's air to air Intercooler vs the Water to air Heat exchanger. The heat exchanger doesn't perform as well, so the water heats up, and the hotter it gets, the more power you...
Forum: Engine, Exhaust, Transmission 10-24-2016, 02:51 PM
Replies: 25
Views: 5,194
Posted By Amputechture
I've been running vented for a couple of weeks...

I've been running vented for a couple of weeks now. Call it placebo effect, but I think my motor feels less labored ever since. To add two cents in, I also think it's a complete and utter rip-off to...
Forum: Engine, Exhaust, Transmission 10-23-2016, 04:10 PM
Replies: 25
Views: 5,194
Posted By Spartarus
Embarrassed as I am to say it, Speed By Design. ...

Embarrassed as I am to say it, Speed By Design.

Not a decision I'd make again. The build quality and engineering were unsatisfactory for me. Not bad, just not up to my standards, and nowhere...
Forum: Engine, Exhaust, Transmission 10-23-2016, 03:57 PM
Replies: 25
Views: 5,194
Posted By Luftwaffel
Check out the new Velox AOS. Can operate...

Check out the new Velox AOS. Can operate basically however you want it to.
Forum: Engine, Exhaust, Transmission 10-23-2016, 08:50 AM
Replies: 25
Views: 5,194
Posted By Spartarus
Just vent it. OEM's used to vent it, the...

Just vent it.

OEM's used to vent it, the only reason they don't now is emissions regulations, specifically regulations about unburned HC's. They used to just call them crankcase breathers.

The...
Forum: Forced Induction 10-11-2016, 02:31 PM
Replies: 141
Views: 58,718
Posted By VerusEric
Just discussed the oil cooler situation with...

Just discussed the oil cooler situation with Geoff from Full-Race and we will be working on an oil cooler kit that can be purchased with (or without) the kit in the coming months. Both him and I...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 09-27-2016, 12:36 PM
Replies: 34
Views: 8,223
Posted By 8RZ
Ah, the 'ol mechanic facial.

Ah, the 'ol mechanic facial.
Forum: Forced Induction 09-19-2016, 11:06 PM
Replies: 41
Views: 32,849
Posted By Kiske
Depends on what you define as best. Everyone is...

Depends on what you define as best. Everyone is going to have different desires depending on what your wanting in a kit. The turbo itself will play a huge part in deciding which kit to get even if...
Forum: Mid-Atlantic 09-06-2016, 12:31 PM
Replies: 366
Views: 71,637
Posted By Jakinit
BRZ - Crystal White Pearl (K1X) - 6MT L Minja ...

BRZ - Crystal White Pearl (K1X) - 6MT L
Minja
Virginia Beach, VA



Sent from my Nexus 6P using Tapatalk
Forum: Forced Induction 08-16-2016, 03:50 PM
Replies: 6,004
Views: 2,036,941
Posted By snowdog
Just installed mine last weekend. I would plan...

Just installed mine last weekend. I would plan on about 10 hours or so depending on your expertise. Nothing really too hard, a few instructions could be clearer.
Forum: Mid-Atlantic 08-13-2016, 03:43 PM
Replies: 7,404
Views: 1,177,648
Posted By alxtheoreo
I saw a white twin with green Enkei Kojin wheels...

I saw a white twin with green Enkei Kojin wheels at Camden of Lansdowne.

Sent from my SM-G930V using Tapatalk
Forum: Forced Induction 08-10-2016, 12:08 AM
Replies: 110
Views: 50,201
Posted By kask2_6.0
Made some really good progress this weekend. ...

Made some really good progress this weekend. Welded an intercooler mount, mounts on the intercooler itself, and some piping. Also finalized a few drawings, confirmed fitment with 3D prints, and...
Forum: Mid-Atlantic 08-04-2016, 10:14 PM
Replies: 1
Views: 1,192
Posted By Worstenemy453
Text me bud 540-642-204seven, i can help you with...

Text me bud 540-642-204seven, i can help you with all of that.
Forum: Forced Induction 08-03-2016, 11:29 AM
Replies: 34
Views: 5,648
Posted By Ross
For anyone wanting to push 400 and north I...

For anyone wanting to push 400 and north I recommend a swap. After you are done dealing with built engine, trans, cost of force induction kit, accessory parts, ect.... a swap does not look so bad. If...
Showing results 1 to 30 of 34

 
Forum Jump

All times are GMT -4. The time now is 02:12 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.