follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Showing results 1 to 23 of 23
Search took 0.01 seconds. Search: Posts Made By: Brz866
Forum: Forced Induction 05-17-2022, 02:12 PM
Replies: 6,004
Views: 2,049,905
Posted By Brz866
Throwing in my 2 cents this is my setup. Perrin...

Throwing in my 2 cents this is my setup. Perrin foam filter with recommended Amazon pipes from another post on here. I can confirm as well that it makes a noticeable difference in performance. As...
Forum: Issues | Warranty | Recalls / TSB 11-03-2021, 12:11 AM
Replies: 7
Views: 2,662
Posted By Brz866
I had alternator whine coming through my speakers...

I had alternator whine coming through my speakers due to a bad ground on the stock harness. Cut the wire, grounded to the frame behind radio, now it's gone. If you ever have another issue with the...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 08-31-2021, 12:12 AM
Replies: 7
Views: 2,873
Posted By Brz866
Never happened to me, but I've heard other fix...

Never happened to me, but I've heard other fix this by blowing compressed air into the drain tube to unclog it. Might be worth a shot.
Forum: Engine, Exhaust, Transmission 07-08-2021, 01:10 PM
Replies: 11
Views: 1,847
Posted By Brz866
From doing research before buying my SB stage 2...

From doing research before buying my SB stage 2 daily it seemed this issue happened the most on ACT kits. Put 10k on the SB kit so far so good with only sti motor and tranny mounts. I've read...
Forum: Engine, Exhaust, Transmission 06-25-2021, 12:53 AM
Replies: 11
Views: 1,847
Posted By Brz866
This sounds like clutch drag and is a common...

This sounds like clutch drag and is a common issue with the ACT clutches on this platform for some reason. You could try raising the clutch pedal for a longer throw but it's usually the ACT clutch at...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 06-08-2021, 02:27 PM
Replies: 13
Views: 1,588
Posted By Brz866
I'm not very familiar with the morimoto...

I'm not very familiar with the morimoto headlights, but my Valenti taillights had hyperflash resistors built in. I cut them out and just used the DD hyper flash relay. The morimotos either don't have...
Forum: Issues | Warranty | Recalls / TSB 06-03-2021, 02:52 PM
Replies: 22
Views: 4,396
Posted By Brz866
That's the issue the Verus fuel starvation door...

That's the issue the Verus fuel starvation door solves. I installed it and have no issues with high g left turns at all.
Forum: Engine, Exhaust, Bolt-Ons 02-11-2021, 04:44 PM
Replies: 18
Views: 3,796
Posted By Brz866
I have the same exact headers and the undertray...

I have the same exact headers and the undertray does not need modified nor does the header rub on it even on stock engine mounts in my case.
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 09-29-2020, 05:41 AM
Replies: 11
Views: 2,490
Posted By Brz866
May also be important to note the color of the...

May also be important to note the color of the bulb is affected by the ballast as well. Bulbs being the same, 5000k using a Chinese ballast will be a different color than the same bulb using an OEM...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 09-25-2020, 05:29 AM
Replies: 11
Views: 2,490
Posted By Brz866
I'd keep your HIDs. Light output wise going to...

I'd keep your HIDs. Light output wise going to LED would be a downgrade in your HID assemblies and could never match the output an HID puts out. IMO 4300K is actually the ideal output. Any higher...
Forum: Forced Induction 09-17-2020, 04:54 AM
Replies: 6,004
Views: 2,049,905
Posted By Brz866
I run 0W-20 amsoil SS with an oil cooler per my...

I run 0W-20 amsoil SS with an oil cooler per my tuners recommendation. C38, 93, standard pulley at the time. He said 5w-30 is a band aid for high oil temp situations if you're pushing it without an...
Forum: Issues | Warranty | Recalls / TSB 09-15-2020, 04:15 AM
Replies: 4
Views: 1,415
Posted By Brz866
I think in this case it's safe to assume the tail...

I think in this case it's safe to assume the tail light gaskets are leaking and that's where the water is coming from. It's a common issue on these cars. I used oem gaskets with 3m yellow sealant....
Forum: Forced Induction 07-01-2020, 04:58 AM
Replies: 4,306
Views: 1,330,567
Posted By Brz866
Centrifugal kits are great for reliability and...

Centrifugal kits are great for reliability and DD'ing as I'm sure you've noticed. That being said I bought the JRSC C38 used with 10k and haven't had a problem. Installed JR oil cooler never had a...
Forum: Engine, Exhaust, Bolt-Ons 08-19-2019, 06:01 PM
Replies: 39
Views: 6,779
Posted By Brz866
Pm'd about cam plate

Pm'd about cam plate
Forum: FR-S / BRZ vs.... 07-11-2019, 03:12 PM
Replies: 2,577
Views: 826,861
Posted By Brz866
I swear I've seen that exact prelude and he did...

I swear I've seen that exact prelude and he did the exact same crap to me too. You wouldn't happen to be around Pittsburgh would you?
Forum: Electronics | Audio | NAV | Infotainment 07-05-2019, 07:44 PM
Replies: 2
Views: 3,002
Posted By Brz866
Sounds like a good solution to your problem is a...

Sounds like a good solution to your problem is a relay harness. That way you pull full power from the battery instead of the stock wiring.
Forum: Forced Induction 06-20-2019, 10:05 PM
Replies: 6,004
Views: 2,049,905
Posted By Brz866
I've always used the k&n filter cleaner and oil...

I've always used the k&n filter cleaner and oil kit. Just follow the directions from the kit and it gets the filter like new. The pre filter sock isn't necessary due to the filter being protected and...
Forum: Forced Induction 02-20-2019, 03:58 PM
Replies: 6,004
Views: 2,049,905
Posted By Brz866
I've worked with Zach at delicious tuning since...

I've worked with Zach at delicious tuning since the first day I installed my JRSC. Tuned on stock pulley and 93 octane and then even tuned for HBP. Always a pleasant experience and has to be one of...
Forum: Forced Induction 12-25-2018, 07:14 PM
Replies: 6,004
Views: 2,049,905
Posted By Brz866
I'd say for sure most people running any c30/c38...

I'd say for sure most people running any c30/c38 kit do not have a built engine. Hell that's the selling point of the kit for some, including myself. Reliable power. Running stock pulley and 91/93 is...
Forum: Forced Induction 12-25-2018, 05:39 PM
Replies: 6,004
Views: 2,049,905
Posted By Brz866
I think the real question is how long will the...

I think the real question is how long will the motor last at that power level. That's an "unsafe" power level no matter how you look at it if your focus is engine longevity and reliability. Now I do...
Forum: Engine, Exhaust, Transmission 11-13-2018, 01:12 AM
Replies: 40
Views: 6,613
Posted By Brz866
Could the problem be related to direct injector...

Could the problem be related to direct injector seals? They're known to make a popping/crackling sound when they fail.
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 07-25-2018, 12:55 AM
Replies: 15
Views: 16,430
Posted By Brz866
Yes it's the Valenti smoked 4th brake light sorry...

Yes it's the Valenti smoked 4th brake light sorry for the late reply.
Forum: Audio/Visual, Electronics, Infotainment, NAV 01-18-2018, 06:54 PM
Replies: 3
OFT
Views: 1,077
Posted By Brz866
Pm'd

Pm'd
Showing results 1 to 23 of 23

 
Forum Jump

All times are GMT -4. The time now is 02:29 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.