follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 144
Search took 6.08 seconds.
Search: Posts Made By: FrickingReallySlow
Forum: Member's Car Journals 03-23-2024, 09:59 PM
Replies: 195
Views: 54,644
Posted By Irace86.2.0
$41k OTD, including taxes, reg, etc., so like...

$41k OTD, including taxes, reg, etc., so like $37k'ish.

Pretty decent deal. 85k miles and some cosmic issues that I'll address, but overall, I'm satisfied.
Forum: BRZ First-Gen (2012+) -- General Topics 03-07-2024, 09:44 PM
Replies: 42
Views: 7,395
Posted By DarkPira7e
Let's say there's a flood and it's catastrophic....

Let's say there's a flood and it's catastrophic. 400 something people report that their car is a total loss and was flooded. The insurance company may take those reports, look at a few of them to...
Forum: Engine, Exhaust, Transmission 02-05-2024, 07:50 PM
Replies: 52
Views: 6,146
Posted By Opie
Engine was installed on Sunday, runs great!...

Engine was installed on Sunday, runs great! Currently have a cheapy oil filter and oil in it along with a magnetic drain plug, will drive it about 50 miles and then drain it, install a Subaru OEM...
Forum: Engine, Exhaust, Transmission 02-03-2024, 12:27 PM
Replies: 52
Views: 6,146
Posted By Opie
Some of you may be wondering, what was the final...

Some of you may be wondering, what was the final cost to rebuild this motor. I've included the parts spreadsheet below. $1,359.94 in parts + $100 machine shop. Total = $1,459.94

This engine also...
Forum: Issues | Warranty | Recalls / TSB 02-01-2024, 02:15 PM
Replies: 11
Views: 3,253
Posted By dragoontwo
Added hyperflash parts and procedures.

Added hyperflash parts and procedures.
Forum: Engine, Exhaust, Transmission 01-19-2024, 11:07 AM
Replies: 52
Views: 6,146
Posted By Opie
Installed the rear main seal yesterday, also went...

Installed the rear main seal yesterday, also went to the dealer and picked up the cam carrier filter screens and a set of plugs. Machine shop got the cams & carriers done in a few hours, picked them...
Forum: Issues | Warranty | Recalls / TSB 01-03-2024, 08:33 PM
Replies: 8
Views: 1,553
Posted By EndlessAzure
3M Black Super Weatherstrip Adhesive. It's a...

3M Black Super Weatherstrip Adhesive. It's a little goopy though.


Silicone or other RTV would work too. Just need to get in there with finger and make sure it gets into whatever seam you're...
Forum: Issues | Warranty | Recalls / TSB 11-20-2023, 05:43 PM
Replies: 8
Views: 1,553
Posted By Opie
Both of those area look odd to me....where the...

Both of those area look odd to me....where the orange arrow is pointing the paint appears cracked. and the entire edge the weather strip attaches to looks bent and out of shape to me (in the red...
Forum: Issues | Warranty | Recalls / TSB 11-20-2023, 12:52 AM
Replies: 8
Views: 1,553
Posted By humfrz
I checked with Bubba and he says to cover the...

I checked with Bubba and he says to cover the edges of the inside of the lid with light oil and coat the trunk gasket with silicone. Place a strong light above the trunk. Then, with the trunk lid...
Forum: Forced Induction 11-11-2023, 12:44 AM
Replies: 4,964
Views: 1,478,257
Posted By ze12o
MAF O-ring

long story short, ive been cleaning my MAF almost every 2 weeks due to MAF fouling. or what i thought it was it at least. my fuel trims would go wack after a few 20psig map pulls.
it would clear...
Forum: Issues | Warranty | Recalls / TSB 10-20-2023, 06:14 PM
Replies: 6
Views: 814
Posted By Grady
I would get silicone vacuum tubing.

I would get silicone vacuum tubing.
Forum: Issues | Warranty | Recalls / TSB 10-15-2023, 09:36 PM
Replies: 6
Views: 814
Posted By new2subaru
I could be wrong but the looks like GP air hose...

I could be wrong but the looks like GP air hose to me. I can make out W P which stands for working pressure.

https://www.gates.com/us/en/fluid-power/industrial-hose/general-purpose.html
Forum: Electronics | Audio | NAV | Infotainment 10-01-2023, 08:40 AM
Replies: 262
Views: 70,320
Posted By Rican_D
Yeah it's an issue, you can probably trim some of...

Yeah it's an issue, you can probably trim some of it. I just forced it in myself.

Sent from my Pixel Fold using Tapatalk
Forum: Issues | Warranty | Recalls / TSB 09-07-2023, 12:43 PM
Replies: 11
Views: 3,253
Posted By dragoontwo
Added links to turn signal recall documents.

Added links to turn signal recall documents.
Forum: Forced Induction 07-05-2023, 09:00 AM
Replies: 4,964
Views: 1,478,257
Posted By B T
It was the shaft of the butterfly valve itself....

It was the shaft of the butterfly valve itself. I'm only on my 2nd vacuum actuator, been lucky to not have as many problems as others. Sorry, not pics but it was about 1/4 inch total movement.
Forum: Forced Induction 07-04-2023, 05:38 PM
Replies: 4,964
Views: 1,478,257
Posted By B T
So, I ran into an issue where my car wasn't...

So, I ran into an issue where my car wasn't experiencing full acceleration on a regular basis. At first I thought it was throttle body not opening all the way as throttle body failures have been...
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 07-02-2023, 04:04 PM
Replies: 146
Views: 38,023
Posted By 900BRZ
July 1 test results from Thunderhill 5-Mile with prototype Killer B baffle

Wanted to share the results in detail on this thread before summarizing elsewhere, because this is where the bulk of this history about this product lives. We have already established baseline data...
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 06-30-2023, 07:11 PM
Replies: 146
Views: 38,023
Posted By 900BRZ
In the attached screenshot you can pretty clearly...

In the attached screenshot you can pretty clearly see the short shift into T5W eliminates the pressure drop on this particular lap. Note that these laps are a bit off the pace from earlier in the...
Forum: Forced Induction 06-18-2023, 03:47 PM
Replies: 14
Views: 1,635
Posted By soundman98
4 windshield washer nozzles in front of...

4 windshield washer nozzles in front of intercooler to mist water onto it
Forum: Software Tuning 05-20-2023, 02:13 PM
Replies: 111
Views: 18,492
Posted By tomm.brz
Apparently in last revisions, ecutek started...

Apparently in last revisions, ecutek started blocking relevant tables like CPC control for boost controller and things like that
Can t confirm it with details yet as i m avoiding update
Forum: Software Tuning 05-16-2023, 03:39 PM
Replies: 111
Views: 18,492
Posted By tomm.brz
yes, i mean the littke usb dongle. ecutek can...

yes, i mean the littke usb dongle. ecutek can remotely update it and kill it or force flash the latest revision of proecu that run with it so make downgrading impossible

but it can also access the...
Forum: Software Tuning 05-16-2023, 05:04 AM
Replies: 111
Views: 18,492
Posted By tomm.brz
me and steve have experienced cases of people...

me and steve have experienced cases of people updating their proecu and the dongle got killed by ecutek remotely
it just stops working totally and ecutek pretend not to know the cause
having you...
Forum: Engine, Exhaust, Transmission 05-12-2023, 10:42 AM
Replies: 3
Views: 758
Posted By tomm.brz
yeah i would n' t worry about 1 single misfire

yeah i would n' t worry about 1 single misfire
Forum: Engine, Exhaust, Transmission 05-12-2023, 09:48 AM
Replies: 3
Views: 758
Posted By Grady
Miss-fires are normal, excessive miss-fires are...

Miss-fires are normal, excessive miss-fires are not. That is why you need multiple to throw a CEL.
Forum: Software Tuning 05-11-2023, 02:17 PM
Replies: 111
Views: 18,492
Posted By tomm.brz
i can t answer because ecutek updated again and i...

i can t answer because ecutek updated again and i havent. So i dont know if they eventually locked up what they told they re gonna lock up.
And it shouldn t affect you as the end user of the tune,...
Forum: Software Tuning 05-09-2023, 12:32 PM
Replies: 111
Views: 18,492
Posted By tomm.brz
you cant as soon as you install an update, the...

you cant
as soon as you install an update, the dongle gets overwritten with the last version of proecu so you can t downgrade even if you make a partition image, the dongle will stop the opening and...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-29-2023, 10:51 PM
Replies: 11
Views: 1,522
Posted By strat61caster
A is parallel-ish, bar bends over steering rod....

A is parallel-ish, bar bends over steering rod. It is currently approximately 180 degrees out from where it should be in your picture.
Forum: Issues | Warranty | Recalls / TSB 03-23-2023, 09:26 PM
Replies: 13
Views: 2,003
Posted By soundman98
the bottom of the trunk weather stripping doesn't...

the bottom of the trunk weather stripping doesn't make any sense to be letting water into the trunk.

the weather stripping coming loose is likely a symptom instead of the cause. you need to look...
Forum: Northern California 02-17-2023, 06:49 PM
Replies: 11,735
Views: 2,808,665
Posted By Djim
Selling my 2017 Hot Lava M/T 86; please see...

Selling my 2017 Hot Lava M/T 86; please see journal below for further details:

https://www.ft86club.com/forums/showthread.php?t=152545

If anyone is interested, also selling my girlfriend's 2017...
Forum: Member's Car Journals 02-13-2023, 05:21 PM
Replies: 4
Views: 737
Posted By Djim
With all this done, the car has sat in this state...

With all this done, the car has sat in this state for a good while now. The initial pictures in the original post were taken just last week, so nothing has changed as I reached a certain "checkpoint"...
Showing results 1 to 30 of 144

 
Forum Jump

All times are GMT -4. The time now is 11:07 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.