follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 18 of 18
Search took 0.01 seconds.
Search: Posts Made By: snowtaipan
Forum: Issues | Warranty | Recalls / TSB 03-08-2023, 07:33 PM
Replies: 14
Views: 1,621
Posted By snowtaipan
P0302 17 BRZ EDELBROCK SC/W DELICIOUS

Hey y'all, my DD decided after a few months to throw a cyl 2 misfire.

Background, swapped to a stage 2 daily by Southbend about 3 months ago. No issues until today. Fuel consumption has been...
Forum: Forced Induction 05-12-2020, 03:00 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
Update "We’re going to configure ROM version...

Update

"We’re going to configure ROM version ZA1JS00C for your BRZ today to see if the performance changes."
-calibrations

They also modified the K00C to test the MAF before they run the new...
Forum: Forced Induction 05-12-2020, 09:49 AM
Replies: 166
Views: 22,520
Posted By snowtaipan
Bro I see your point, I see Mike's, in the end no...

Bro I see your point, I see Mike's, in the end no one likes CARB. y'all can agree on that, the rest is semantics.
Forum: Forced Induction 05-09-2020, 08:38 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
Talking Here are the two logs after the fix. Its actually...

Here are the two logs after the fix. Its actually trimming on the negative side a bit. I think if it got 10 minutes of work it would be almost decent :respekt:...
Forum: Forced Induction 05-05-2020, 02:24 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
Well I'm going to run a final set of tests on the...

Well I'm going to run a final set of tests on the HPFS, I'll post the results, and then I'm going to reassemble everything, hopefully complete by the end of the day. I have some work that's screwing...
Forum: Forced Induction 05-05-2020, 02:19 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
Both manifold gaskets look fine, they weren't...

Both manifold gaskets look fine, they weren't pinched or cut, still pliable.



Exactly right, that same assembly is used on jeeps. Apparently it's plugged inside, I checked and didn't get any...
Forum: Forced Induction 05-03-2020, 09:44 AM
Replies: 166
Views: 22,520
Posted By snowtaipan
The codes I have come on after to drive cycle....

The codes I have come on after to drive cycle. There not soft codes.
P0171/0170/117b all have 3 things in common: HP injectors, HPF fuel system, and ECM

All three DTCs are based off...
Forum: Forced Induction 05-02-2020, 09:03 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
SITREP From Calibration@Edelbrock Here are...

SITREP

From Calibration@Edelbrock
Here are some more thoughts after a brainstorming session with some of our department. Please understand that we are trying to check all the boxes off before we...
Forum: Forced Induction 04-30-2020, 04:32 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
Per Edelbrock I pulled the fuel supply line to...

Per Edelbrock I pulled the fuel supply line to test. Standard was 50-75 PSI I was at 59psi at idle. After turning off pressure slowly dropped from 59 to 40 over probably 7 minutes, then held at 40...
Forum: Forced Induction 04-28-2020, 07:59 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
update from Edelbrock Cal: Considering the...

update from Edelbrock Cal:
Considering the DTC’s, high positive fuel trims at idle and extensive manifold leak checks already done, please get a fuel pressure reading from the low pressure pump at...
Forum: Forced Induction 04-28-2020, 04:22 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
So from what I'm tracking, the fuel pressure...

So from what I'm tracking, the fuel pressure sensor is involved with calibrating the fuel mixture. If it's bad, maybe that's the issue. However, when I backpinned it with the IGN ON, it wasn't...
Forum: Forced Induction 04-26-2020, 04:12 PM
Replies: 5
Views: 654
Posted By snowtaipan
I have a 2017 yellow series, I didn't run into...

I have a 2017 yellow series, I didn't run into that issue. You sure your SC is seated correctly?

Did you already tighten the lower ECU bolt?
Forum: Forced Induction 04-25-2020, 04:37 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
Unhappy So I rechecked hoses, wires, clamps etc. Re...

So I rechecked hoses, wires, clamps etc.
Re flashed the ECU for I think the 5th time
Started logging before I cranked it
Idled until LTFT stabilized (Again around 35-40)
Held at 2k RPM for 1...
Forum: Forced Induction 04-24-2020, 03:51 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
New injectors is an expensive fix, especially for...

New injectors is an expensive fix, especially for a kit that's touted as "bolt on" and designed for a stock car.
Forum: Forced Induction 04-24-2020, 03:39 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
Dude I'd never used datazap, that's on point!

Dude I'd never used datazap, that's on point!
Forum: Forced Induction 04-24-2020, 11:45 AM
Replies: 166
Views: 22,520
Posted By snowtaipan
The Edelbrock runs a breather hose from the air...

The Edelbrock runs a breather hose from the air filter to the front left PCV.
The right rear PCV hose routes foreward to the nose of the SC. So I dont think it's seeing boos. It also doesn't replace...
Forum: Forced Induction 04-24-2020, 01:39 AM
Replies: 166
Views: 22,520
Posted By snowtaipan
I can see LTFT and STFT drop way down at high...

I can see LTFT and STFT drop way down at high RPM, thats classic vacuum leak. I just gotta find it
Forum: Forced Induction 04-23-2020, 06:39 PM
Replies: 166
Views: 22,520
Posted By snowtaipan
I am using torque, it's not great for logging but...

I am using torque, it's not great for logging but I can try. What targets?

I just unclipped and cleaned the injectors, retorqued the hold down bolts, and retorqued the manifold bolts.
Showing results 1 to 18 of 18

 
Forum Jump

All times are GMT -4. The time now is 03:20 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.