follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 7 of 7
Search took 1.09 seconds.
Search: Posts Made By: jRuN
Forum: Forced Induction 06-09-2019, 03:58 PM
Replies: 8
Views: 3,597
Posted By KingJon1991
the an fitting that go on the flex fuel line is...

the an fitting that go on the flex fuel line is 3/8 quick connent (2) -6 an and you will need (3) 90 degree -6 and (1) 45 degree -6 and -6 hoses (1) 5/16 quick connent (1) 5/16 fuel rail...
Forum: Engine, Exhaust, Transmission 12-27-2018, 03:21 PM
Replies: 28
Views: 4,427
Posted By toast
Drill out the rivets, remove a single bolt...

Drill out the rivets, remove a single bolt (showing in the pic) and put a cap over the hole in the airbox. The cap doesn't have to be airtight since it is upstream of the air filter.

The reason...
Forum: Engine, Exhaust, Transmission 12-27-2018, 02:48 PM
Replies: 28
Views: 4,427
Posted By JD001
All gone if you go down the CAI route...

All gone if you go down the CAI route...
Forum: Software Tuning 07-18-2018, 08:22 AM
Replies: 20
Views: 9,200
Posted By steve99
OK ill just clear up a couple of things ...

OK ill just clear up a couple of things


1. If you have an Ecutek tuned rom in ecu then only Ecutek can overwrite that back to stock. Once its been returned to stock with ecuteck then it can be...
Forum: Electronics | Audio | NAV | Infotainment 07-15-2018, 02:51 PM
Replies: 3
Views: 4,460
Posted By FRSBRZGT86FAN
With garmin and mazda connect systems its an easy...

With garmin and mazda connect systems its an easy hack, of dragging torrented updated 2018 maps to the sd card and using it, in fact theres even an open source maps available that are super accurate....
Forum: Software Tuning 03-31-2018, 10:32 AM
Replies: 135
Views: 32,417
Posted By steve99
IAM is a little tricky IAM initial set...

IAM is a little tricky


IAM initial set to 0.7 in tune/rom


If you set IAM initial to 0.7 then at each start-up the ECU will use IAM initial as 0.7, Unless the IAM had fallen Below the IAM...
Forum: Software Tuning 03-19-2018, 03:19 AM
Replies: 661
Views: 197,392
Posted By steve99
OFT Openflash V4 tunes released for 2017+ with Launch/FFS

OFT Openflash V4 tunes released for 2017+ with Launch/FFS


WARNING : USE THE V4 DEFINITIONS THAT COME IN V4 TUNE PACK, DO NOT USE OLD DEFINITIONS, CLEAR THEM OUT OF ROMRAIDER. note this only...
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -4. The time now is 08:07 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.