follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Showing results 1 to 16 of 16
Search took 0.71 seconds. Search: Posts Made By: maregt
Forum: Tracking / Autocross / HPDE / Drifting 03-10-2020, 09:39 AM
Replies: 77
Views: 15,528
Posted By Racecomp Engineering
Swaybars have gotten a bad rap online for some...

Swaybars have gotten a bad rap online for some reason. The idea of using only the 4 corner springs is really appealing to some but it's just not realistic most of the time.

- Andrew
Forum: Tracking / Autocross / HPDE / Drifting 03-09-2020, 09:20 AM
Replies: 77
Views: 15,528
Posted By M0nk3y
Because the setup works? :iono: There...

Because the setup works? :iono:

There becomes a point where calculator and spreadsheets only take you so far, then there is actual experience.

You can't mimic a front bar with springs though,...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 12-20-2019, 08:08 AM
Replies: 832
Views: 291,732
Posted By Takumi788
Just started a rebuild on my front stage II...

Just started a rebuild on my front stage II calipers. My passenger side inner pad wore twice as fast as the outer and a little crooked. RR Racing was very helpful with sending me a link to the...
Forum: BRZ Photos, Videos, Wallpapers, Gallery Forum 09-28-2019, 12:46 PM
Replies: 408
Views: 274,227
Posted By tuti34
bella Enviado desde mi Redmi 5 Plus mediante...

bella

Enviado desde mi Redmi 5 Plus mediante Tapatalk
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 06-13-2019, 03:50 PM
Replies: 8
Views: 2,978
Posted By Racecomp Engineering
An adjustable toe arm is IMO worth it either way....

An adjustable toe arm is IMO worth it either way. I don't like the stock one.

Adjusting rear alignment is a little bit of a pain but it just takes some patience.

- Andrew
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 06-13-2019, 03:44 PM
Replies: 8
Views: 2,978
Posted By NoHaveMSG
The toe arm attaches to the front of the knuckle,...

The toe arm attaches to the front of the knuckle, so increasing negative camber will toe it out. Positive camber will toe it in. I don't know how much a degree will change it. I have toe plates and a...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 06-13-2019, 02:45 PM
Replies: 8
Views: 2,978
Posted By NoHaveMSG
It will effect it quite a bit. Maybe not as...

It will effect it quite a bit. Maybe not as severely as an LCA being the UCA is closer to where the toe arm connects to the knuckle. But it will change the toe a lot.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 05-10-2019, 02:45 PM
Replies: 9
Views: 1,504
Posted By nikitopo
You can check here: ...

You can check here: http://www.ft86club.com/forums/showthread.php?t=131716

They are +1mm thicker (approx. 25% more stiff) and the rear is adjustable.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 05-10-2019, 07:27 AM
Replies: 9
Views: 1,504
Posted By nikitopo
This the correct fit. When you torque the clamp,...

This the correct fit. When you torque the clamp, the bushing ends will touch each other.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 05-10-2019, 07:23 AM
Replies: 9
Views: 1,504
Posted By gpvecchi
I have the STi bush on the front bar, it says 13...

I have the STi bush on the front bar, it says 13 while bar is 18.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 05-09-2019, 04:59 PM
Replies: 9
Views: 1,504
Posted By gpvecchi
20464CA020 is correct, the old bushing was...

20464CA020 is correct, the old bushing was 20464CA010.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 02-11-2018, 06:54 PM
Replies: 15
Views: 3,693
Posted By Gunman
:cheers: Everyone has their own theories. I ran...

:cheers: Everyone has their own theories. I ran my plan past my boss at the time, who Car and Driver call, "America's most prolific and successful designer of racecars". So I'm very comfortable...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 02-11-2018, 06:44 PM
Replies: 15
Views: 3,693
Posted By Lunatic
Here's a picture. Contact Sam at Cusco USA,...

Here's a picture.
Contact Sam at Cusco USA, sam@cuscousainc.com. Ask him about what he put on my Lunatic Racing FRS.
Forum: BRZ Photos, Videos, Wallpapers, Gallery Forum 02-23-2017, 06:21 AM
Replies: 408
Views: 274,227
Posted By Gunman
Great wheel choice!!

Great wheel choice!!
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 02-07-2017, 05:36 AM
Replies: 832
Views: 291,732
Posted By Cartman
I found the ds 2500 have very little bite, and I...

I found the ds 2500 have very little bite, and I was not a fan of that. I have GT3 ducts and didnt experience fade on thay track.

As for the ST45 mu, the specs ive found only mention mu at...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 01-09-2017, 08:27 AM
Replies: 832
Views: 291,732
Posted By frslee
After 10mm + 3mm spacers, it cleared by 2-3mm. So...

After 10mm + 3mm spacers, it cleared by 2-3mm. So it was very close.
Showing results 1 to 16 of 16

 
Forum Jump

All times are GMT -4. The time now is 12:06 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.