follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 256
Search took 1.07 seconds.
Search: Posts Made By: Yobiwan
Forum: Forced Induction 11-25-2022, 11:33 AM
Replies: 3
Views: 1,357
Posted By Irace86.2.0
I feel like an easy solution for the stock basket...

I feel like an easy solution for the stock basket FPR is either to drill it out, so it is always open or weld it shut, but I decided to just buy the DW dual module.
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 09-09-2022, 04:05 AM
Replies: 34
Views: 6,249
Posted By x808drifter
So where's the wind testing data? There anything...

So where's the wind testing data? There anything done to under the car? Wheel sizes? Why is it on bags? Something nobody who seriously races these car would do.

Race
Inspired
Cosmetic...
Forum: Software Tuning 08-02-2022, 10:50 AM
Replies: 42
Views: 5,886
Posted By mrjj
+1 Losing steve99 is losing 50% of this forum's...

+1
Losing steve99 is losing 50% of this forum's value.
He was always friendly and informative, even when answering the same "stupid" questions over and over again.


If you really don't want him...
Forum: Software Tuning 08-02-2022, 08:28 AM
Replies: 42
Views: 5,886
Posted By tomm.brz
They banned steve99 because someone reported him...

They banned steve99 because someone reported him to the moderators, saying that he s asking money for its service


The moderators, other than being INEXISTENT the whole time, are asking him 200...
Forum: Software Tuning 06-03-2022, 10:20 AM
Replies: 7
Views: 1,434
Posted By Wayno
If you want more range, then reduce base timing...

If you want more range, then reduce base timing and increase KCA, as you said. You could do 4 deg on entire both tables, including the cells that are 0 in KCA.
Forum: Engine Swaps 05-05-2022, 03:10 PM
Replies: 281
Views: 69,374
Posted By elBarto
The engine is running and has been on the dyno. ...

The engine is running and has been on the dyno.

https://i.postimg.cc/bSPz90hP/EMS-FA20-FA24.jpg (https://postimg.cc/bSPz90hP)


[/URL][URL="https://fb.watch/cPSZ-e5s7F/"]Facebook video of the...
Forum: Software Tuning 05-04-2022, 06:12 AM
Replies: 38
Views: 4,558
Posted By steve99
Does your tune have FFS flat foot upshift enabled...

Does your tune have FFS flat foot upshift enabled ? if so it migh be the clutch detection switch faulty trigging the FFS function, or your resting foot slightly on clutch trigfering the FFS function...
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 02-01-2022, 01:48 PM
Replies: 93
Views: 20,461
Posted By timurrrr
Oh, yet another thread on oil coolers for gen.1...

Oh, yet another thread on oil coolers for gen.1 with ZDan saying they are not needed :)

Coming back to the original topic of oil coolers for gen.2, most/all aftermarket options are not available /...
Forum: Software Tuning 12-03-2019, 10:00 AM
Replies: 90
Views: 29,403
Posted By makinen
As tested at the point daily commuted, it is...

As tested at the point daily commuted, it is different from VSC Sport. Another big gain by this mod is the hill climb assist. Really comfortable. But people live at the flat road may not feel like...
Forum: Software Tuning 11-18-2019, 04:17 AM
Replies: 6
Views: 1,485
Posted By tomm.brz
I dont know, shouldn t the first 2 rows active...

I dont know, shouldn t the first 2 rows active during cols start? He said cold start is good
Forum: Software Tuning 11-08-2019, 08:39 AM
Replies: 90
Views: 29,403
Posted By Yoshoobaroo
Just ordered a 17 ABS module off eBay. I’ll...

Just ordered a 17 ABS module off eBay.
I’ll report back with my findings with my stock 13 cluster. I don’t care about hill start, but it’s a good way of ensuring the module works as intended.
Forum: Software Tuning 10-28-2019, 10:50 PM
Replies: 139
Views: 61,339
Posted By steve99
Its highly unlikely that anyone like ztan is...

Its highly unlikely that anyone like ztan is going to develop an opensource flex fuel tune for the 2017+ cars. It requires someone with a high level of skill to spend hundreds of hours of their time...
Forum: Engine Swaps 10-15-2019, 07:17 AM
Replies: 11
Views: 4,899
Posted By DBW
I just did a 2019 engine swap into a 2015 BRZ for...

I just did a 2019 engine swap into a 2015 BRZ for a customer. Its mostly a straight forward swap but the newer gen motors run different crank/cam pick up strategy along with a different...
Forum: Software Tuning 07-12-2019, 10:38 PM
Replies: 15
Views: 5,079
Posted By steve99
What scaling did you put in for the 1050...

What scaling did you put in for the 1050 injectors, if you put 1050 thats for 40 psi fuel pressure these cars about 60 so for 1050 you neec to put in about 1260 in the scalar not 1050.


Also in...
Forum: Software Tuning 07-12-2019, 06:50 PM
Replies: 15
Views: 5,079
Posted By steve99
Ok with cranking fueling its a raw pulse width ,...

Ok with cranking fueling its a raw pulse width , and its not effected by injector scaler.


So you need to compensate for the bigger injectors.


Also the bigger injectprs take a bit more time...
Forum: Forced Induction 07-04-2019, 10:21 PM
Replies: 1,048
Views: 428,448
Posted By Harlock
Nope, just curious.

Nope, just curious.
Forum: Forced Induction 05-10-2019, 12:40 PM
Replies: 51
Views: 13,571
Posted By falcon_wizard
Max psi was 17. Max hp 398 crank, 307 whp on a...

Max psi was 17. Max hp 398 crank, 307 whp on a Maha dyno. Max Crank TQ was about 314 pdft, about 258wtq. It was tuned for overall daily drivability/reliability and overall performance across the...
Forum: Forced Induction 03-14-2019, 11:39 AM
Replies: 12
Views: 4,589
Posted By gtengr
FI raises cylinder pressure rather than the...

FI raises cylinder pressure rather than the compression ratio. The static and dynamic compression ratios are mechanical characteristics of the engine. Static compression assumes the cylinder is...
Forum: Forced Induction 03-13-2019, 02:32 PM
Replies: 12
Views: 4,589
Posted By elitegunslinger
Safe Boost Compression Options

This chart I made utilizing information I've found from previous safe boost levels on the stock motor of 12.5:1 it seems like these engines are good for a final compression of about 22 or less on...
Forum: Software Tuning 03-11-2019, 07:04 AM
Replies: 57
Views: 29,185
Posted By solidsnake11
I used ecuflash to flash A01G hybrid. Said yes to...

I used ecuflash to flash A01G hybrid. Said yes to correct checksum in ecuflash then flashed. This also helped idle after a rev. Thank you guys for your time and help.
Forum: Software Tuning 02-18-2019, 12:19 AM
Replies: 1
Views: 828
Posted By steve99
As per the oft e85 tunes you need to increase the...

As per the oft e85 tunes you need to increase the gdi pressure tables and also alter the port injector scale r to account for the ethanol.


So as you said about 7% increse on the gdi pressure and...
Forum: Software Tuning 02-16-2019, 07:19 AM
Replies: 57
Views: 29,185
Posted By steve99
Anything is possible but reverse engineering...

Anything is possible but reverse engineering andwriting ecu code is not an easy task.


Wjile ztan has done the bulk of ghe work on the manual A01G rom which is what i believe @Yobiwan...
Forum: FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum 02-10-2019, 10:11 PM
Replies: 2,561
Views: 814,234
Posted By Lincoln Logs
Been going a little crazy with the photos lately....

Been going a little crazy with the photos lately.

https://farm8.staticflickr.com/7832/47003934372_b40285d911_h.jpg

https://farm8.staticflickr.com/7816/47003933932_31cb058656_h.jpg
Forum: FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum 02-10-2019, 03:27 PM
Replies: 2,561
Views: 814,234
Posted By Ashikabi
Agreed. This is beautiful

Agreed. This is beautiful
Forum: FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum 02-10-2019, 03:14 PM
Replies: 2,561
Views: 814,234
Posted By Clipdat
Love the lighting and overall composition of this...

Love the lighting and overall composition of this photo. Great shot!


http://www.ft86club.com/forums/attachment.php?attachmentid=174944&stc=1&d=1549691615
Forum: Software Tuning 01-31-2019, 06:29 AM
Replies: 57
Views: 29,185
Posted By tomm.brz
That's great Yobiwan, is it a pure SD so? or...

That's great Yobiwan,
is it a pure SD so? or hybrid?

I hate SD on ecutek, the volumetric efficiency table is annoying to tune, and that SD MAF table you have would be a lot better


a little...
Forum: Engine, Exhaust, Transmission 01-29-2019, 08:17 AM
Replies: 94
Views: 47,650
Posted By sam69
Been doing more research on the oil pump cover...

Been doing more research on the oil pump cover plate so even though I've added a couple more fixings to it I thought I'd check just how well it seals so did a test with bearing blue . :confused0068:...
Forum: Software Tuning 01-16-2019, 09:45 PM
Replies: 18
Views: 4,909
Posted By steve99
The deatworks setting will be compensating for...

The deatworks setting will be compensating for the bigger injectors


stock is 228cc


as the crank tables and tip in tables are a raw pulse width rarter than flow you need to compensate for...
Forum: Software Tuning 01-09-2019, 05:12 AM
Replies: 7
Views: 2,185
Posted By steve99
Some info here But your going to have to...

Some info here


But your going to have to scale it from scratch


https://www.ft86club.com/forums/showthread.php?t=106496
Forum: Forced Induction 12-28-2018, 10:17 AM
Replies: 275
Sticky: FI Dyno thread
Views: 242,669
Posted By tomm.brz
Yobiwan , you had the hks v2 with 45mm...

Yobiwan , you had the hks v2 with 45mm restrictor, why the change?
Showing results 1 to 30 of 256

 
Forum Jump

All times are GMT -4. The time now is 11:59 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.