follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 15 of 15
Search took 4.23 seconds.
Search: Posts Made By: nerve86
Forum: Software Tuning 05-31-2023, 06:20 PM
Replies: 112
Views: 18,771
Posted By tomm.brz
With boost controller on CPC output not for sure...

With boost controller on CPC output not for sure if keeping us tune
I still tune us people but I upgrade them "somehow" to euro tune first
Forum: Software Tuning 08-02-2022, 08:41 AM
Replies: 42
Views: 5,913
Posted By tomm.brz
some people are just bad it s worse though...

some people are just bad

it s worse though that they re asking 200 usd MONTHLY to Steve to unlock its profile
Forum: Software Tuning 08-02-2022, 08:28 AM
Replies: 42
Views: 5,913
Posted By tomm.brz
They banned steve99 because someone reported him...

They banned steve99 because someone reported him to the moderators, saying that he s asking money for its service


The moderators, other than being INEXISTENT the whole time, are asking him 200...
Forum: Software Tuning 07-02-2022, 07:40 PM
Replies: 3
Views: 1,993
Posted By steve99
you dont need custom map the stock table...

you dont need custom map


the stock table can effectivly disable overun fuel cut


go to ecutek maps
select folder Fueling then Overun
Forum: Software Tuning 06-03-2022, 07:42 AM
Replies: 13
Views: 1,650
Posted By steve99
sent you private message

sent you private message
Forum: Software Tuning 02-22-2022, 02:42 AM
Replies: 7
Views: 2,241
Posted By tomm.brz
and you can t access the engine load limiter...

and you can t access the engine load limiter table, and that could be a problem if your setup will go over 1.3 ( you could trick things to avoid the leanness it would cause if you are skilled, but...
Forum: Software Tuning 02-22-2022, 12:57 AM
Replies: 7
Views: 2,241
Posted By steve99
Note if you have not purchased the racerom...

Note if you have not purchased the racerom extension pack from your tuner you cannot access modes 2,3,4 or the advanced racerom fesatures like ecutel closed loop , flex fuel speed density as seen in...
Forum: Software Tuning 01-15-2021, 04:47 AM
Replies: 4
Views: 1,589
Posted By tomm.brz
what he wants like the cooper s doesnt come with...

what he wants like the cooper s doesnt come with the stock tune
with oft you can t do much, you can put some pops and bangs in the low engine load range of the ignition timing base table but then...
Forum: Software Tuning 06-14-2020, 06:55 AM
Replies: 3
Views: 1,054
Posted By tomm.brz
i do this: Do not use custom map for that Use...

i do this: Do not use custom map for that
Use Ecutek COOLANT PRESSURE (CP) sensor

you can scale your sensor there and apply SMOOTHING
put a smoothing of 0.2 (1 is no smoothing) and you ll...
Forum: Software Tuning 06-14-2020, 06:03 AM
Replies: 3
Views: 1,054
Posted By Dom2497
Ecutek - Using rear 02 for a different sensor

As per title, I am using the rear 02 sensor for a oil pressure input. All ok but I can see the voltage feed to the sensor which I am taking from the rear 02 osciliates. Reading around it's because I...
Forum: Software Tuning 01-07-2019, 10:50 PM
Replies: 16
Views: 4,690
Posted By Tor
Unfortunately, the values are not fixed. They...

Unfortunately, the values are not fixed. They tend to wander off the more miles you drive. So if zero is e.g. 15 on a fresh flash, it might be e.g. 13 after driving the car for a while.
...
Forum: Software Tuning 07-30-2018, 06:34 PM
Replies: 26
Views: 14,081
Posted By Tor
"Ecutek vs. OFT” - the ultimate answer

I have switched to Ecutek and used it for about 1/2 year now and want to share my opinion or make a mini review or whatever you want to call it... I actually wrote the whole post some months ago but...
Forum: Software Tuning 07-28-2018, 01:05 AM
Replies: 33
Views: 22,676
Posted By erebuswarrior
E85 Overrun Pops & Fire on NA

After tuning for quite a few CALID's of the 86 community I now have a better understanding of my version of pops and bangs. You'll want to edit mainly 3 things. Overrun Enrich RPM Delta: This is the...
Forum: Software Tuning 04-24-2018, 01:07 PM
Replies: 4
Views: 869
Posted By Tor
Gruppe-S header/overpipe, stock frontpipe,...

Gruppe-S header/overpipe, stock frontpipe, Milltek midpipe/muffler.

Fully automated pops (no feathering of the pedal or anything), using 3 custom Ecutek tables. Adjustable in volume via a custom...
Forum: Software Tuning 03-08-2016, 06:03 AM
Replies: 703
Views: 454,467
Posted By eddieflyinv
Has anyone considered adjusting the Desired...

Has anyone considered adjusting the Desired Overrun Mass Airflow Tables ? Wondering if adjusting the numbers in those tables to lower values would help with the higher rpm crackles. Less air +...
Showing results 1 to 15 of 15

 
Forum Jump

All times are GMT -4. The time now is 08:58 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.