follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 8 1 2345 Last »
Showing results 1 to 30 of 215
Search took 2.74 seconds. Search: Posts Made By: dragoontwo
Forum: BRZ Second-Gen (2022+) -- General Topics 04-01-2024, 09:17 AM
Replies: 1,504
Views: 275,327
Posted By DocWalt
"lack of maintenance" on a sealed part? ~18k...

"lack of maintenance" on a sealed part?

~18k miles and 400 autocross runs with wide sticky tires. "abuse" would be a good way to put it.
Forum: Tracking / Autocross / HPDE / Drifting 03-09-2024, 06:05 PM
Replies: 34
Views: 2,521
Posted By DocWalt
First gen front hubs bolt right into a second gen...

First gen front hubs bolt right into a second gen and work perfectly fine. I replaced mine with a Timken which is *much* chunkier. Time will tell if it holds up better.
...
Forum: Tracking / Autocross / HPDE / Drifting 03-08-2024, 12:25 PM
Replies: 62
Views: 5,220
Posted By RedReplicant
Below 140mm front pinchweld to ground, per 949

Below 140mm front pinchweld to ground, per 949
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 03-02-2024, 11:49 AM
Replies: 10,278
Views: 788,432
Posted By weederr33
Hey everyone, just wanted to let you know the...

Hey everyone, just wanted to let you know the site will be down for maintenance for 30 hours.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 02-19-2024, 09:24 AM
Replies: 265
Views: 86,015
Posted By DocWalt
Another alternative version:...

Another alternative version: https://outboundmotorsports.com/products/gr86-brz-anti-squat-bumpsteer-correction-mount
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 02-06-2024, 12:03 PM
Replies: 26
Views: 5,756
Posted By timurrrr
Made more progress on the project, and I'm...

Made more progress on the project, and I'm crossing out a few geometrical challenges with each iteration. Got a new prototype from the manufacturer, took some measurements and figured out what to do...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 12-14-2023, 02:45 AM
Replies: 10,278
Views: 788,432
Posted By x808drifter
Damn.. can't even thank someone's post right now.

Damn.. can't even thank someone's post right now.
Forum: Engine, Exhaust, Transmission 12-11-2023, 01:14 AM
Replies: 58
Views: 3,594
Posted By twistednoble
She's all back together and started first crank....

She's all back together and started first crank. Many thanks to those that pitched in and put up with my stubbornness.

The clutch effort is insanely smooth with the new TOB and fresh grease. To...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-27-2023, 12:25 AM
Replies: 105
Views: 29,596
Posted By CSG Mike
18mm front 17mm rear, including the backing plate.

18mm front 17mm rear, including the backing plate.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-22-2023, 10:29 AM
Replies: 105
Views: 29,596
Posted By CSG Mike
The compounds listed are the ones that are plug...

The compounds listed are the ones that are plug and play, easy for anyone to use with little to no additional guidance.

There are many, many other compounds prescribed on a case by case basis,...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-05-2023, 10:44 AM
Replies: 4
Views: 1,044
Posted By 949 Racing
86 Xida overview from our shop ...

86 Xida overview from our shop

https://youtu.be/nSLO-312Y0M
Forum: DIY (Do-It-Yourself) Guides 10-09-2023, 11:39 AM
Replies: 301
Views: 134,083
Posted By DocWalt
I'll grab one. Not 100% "done" there, I want to...

I'll grab one. Not 100% "done" there, I want to glue it up like Toyota did:


https://i.postimg.cc/7Z4f8PSm/PXL-20230225-164223389.jpg




edit: added my own terrible pictures
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 08-13-2023, 09:46 PM
Replies: 26
Views: 2,447
Posted By soundman98
no motor ever drains completely. that's why...

no motor ever drains completely.

that's why it's important to warm up the motor, and get the particulates to be held in suspension so they come out as soon as possible.
Forum: BRZ Second-Gen (2022+) -- General Topics 07-26-2023, 04:48 AM
Replies: 53
Views: 8,349
Posted By subaruslow
They say "ts"

They say "ts"
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 05-19-2023, 06:46 AM
Replies: 13,288
Views: 2,797,346
Posted By ScoobsMcGee
https://pbs.twimg.com/media/FwbP9d3XgAU7mMz?format...

https://pbs.twimg.com/media/FwbP9d3XgAU7mMz?format=jpg&name=small
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 05-12-2023, 11:33 AM
Replies: 41
Views: 5,291
Posted By 949 Racing
Tecnas will have about 60% of the total damping...

Tecnas will have about 60% of the total damping range of Xidas. So on the softer settings you wouldn't notice much difference. But if you're running say 255 super200's, 4" splitter and a huge wing...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 05-03-2023, 08:44 AM
Replies: 10,278
Views: 788,432
Posted By Captain Snooze
Don't use this, obviously. 220350

Don't use this, obviously.


220350
Forum: Engine, Exhaust, Transmission 04-30-2023, 10:10 AM
Replies: 44
Views: 4,481
Posted By spcmafia
Rattle is gone. Might have to change the...

Rattle is gone.
Might have to change the position of the clutch back to where it was before, slightly lower than the brake.

Now I can hear the transmission turning over, but I believe its the...
Forum: Engine, Exhaust, Transmission 04-29-2023, 04:48 PM
Replies: 44
Views: 4,481
Posted By spcmafia
IT LIVES!!! Semi panic attack when the car...

IT LIVES!!! Semi panic attack when the car wouldn’t start. I had forgotten to plug a small pin from the starter back in. The other one was after installing the new slave cylinder and the clutch...
Forum: Engine, Exhaust, Transmission 04-28-2023, 05:12 PM
Replies: 44
Views: 4,481
Posted By spcmafia
Yes I did! Sent from my iPhone using...

Yes I did!


Sent from my iPhone using Tapatalk
Forum: BRZ Second-Gen (2022+) -- General Topics 04-26-2023, 12:50 AM
Replies: 27
Views: 3,388
Posted By Strat_FRS
EL vs UEL Header Showdown

Plus an in-depth view of clearing your oil pickup.

Thought you will enjoy this episode.

https://youtu.be/oMjJgCpFhOs
Forum: Tracking / Autocross / HPDE / Drifting 04-24-2023, 04:37 PM
Replies: 146
Views: 34,084
Posted By Opie
So after never experiencing this issue before,...

So after never experiencing this issue before, after 6 years of tracking it happened to me for the first time at Barber Motorsports Park earlier this month. Complete loss of power steering assistance...
Forum: Member's Car Journals 04-20-2023, 11:47 AM
Replies: 99
Views: 13,075
Posted By DocWalt
No slippage, they've been great.

No slippage, they've been great.
Forum: Engine, Exhaust, Transmission 04-19-2023, 12:54 PM
Replies: 17
Views: 2,085
Posted By KillerBMotorsport
Yep. Guys do all kinds of things to get that last...

Yep. Guys do all kinds of things to get that last bit out. Notch the bottom, drill a hole, grind some threads off jack or ramp on one side to tip the car... The press formed thread insert also...
Forum: Engine, Exhaust, Transmission 04-19-2023, 12:49 PM
Replies: 17
Views: 2,085
Posted By Ultramaroon
I cut mine down to the depth of the female...

I cut mine down to the depth of the female threads.

And that drop light is just fine.
Forum: Site Announcements / Questions / Issues 04-16-2023, 07:24 PM
Replies: 50
Sticky: Reporting Spam
Views: 21,715
Posted By ichitaka05
I’m glad you know Japanese lol

I’m glad you know Japanese lol
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 03-29-2023, 09:38 PM
Replies: 58
Views: 9,587
Posted By Sapphireho
I raced commando.

I raced commando.
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 03-28-2023, 12:29 PM
Replies: 58
Views: 9,587
Posted By spcmafia
Had to look them up, and I gotta say, those are...

Had to look them up, and I gotta say, those are really nice.
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 03-24-2023, 11:55 AM
Replies: 44
Views: 8,068
Posted By NoHaveMSG
I thought they performed decent, it's just hard...

I thought they performed decent, it's just hard to compare because it wasn't a car I was familiar with and it was about 4 years ago. It was a rented FRS on 18's with lowering springs, maybe...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 03-24-2023, 11:47 AM
Replies: 44
Views: 8,068
Posted By Espi
a great bang for buck I am currently enjoying the...

a great bang for buck I am currently enjoying the Falken Azenis RT615K+

Once they warm up talk about GRIP! Great for AutoX and track days and best of all on the super affordable side.
Showing results 1 to 30 of 215
Page 1 of 8 1 2345 Last »

 
Forum Jump

All times are GMT -4. The time now is 04:36 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.