Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB

		Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Search Results

Showing results 1 to 15 of 15
Search took 0.35 seconds. Search: Posts Made By: IsaiahW

Forum: Engine, Exhaust, Transmission

04-16-2024, 01:24 PM

Replies: 10

Quarter panel replacement procedure

Views: 434

Posted By Ultramaroon

Opie shared the BRZ body repair manual in this...

Opie shared the BRZ body repair manual in this post (https://www.ft86club.com/forums/showthread.php?p=3604206#post3604206). Snag it while it's still up.

Forum: Member's Car Journals

04-16-2024, 01:18 PM

Replies: 326

2013 BRZ Rebuild, totalled to track car.

Views: 84,949

Posted By Opie

There are no holes in the parts where they need...

There are no holes in the parts where they need to be spot welded. The sections that bolt up will help get it close. I used this...

Forum: Engine, Exhaust, Transmission

04-05-2024, 02:16 PM

Replies: 10

Quarter panel replacement procedure

Views: 434

Posted By Ultramaroon

https://gt86stuff.onrender.com/t3Portal/index.html

https://gt86stuff.onrender.com/t3Portal/index.html

Forum: Engine, Exhaust, Transmission

09-17-2023, 09:49 AM

Replies: 9

How f’ed is too F’ed

Views: 1,456

Posted By soundman98

but if you're going to turn it into a...

but if you're going to turn it into a track-prepped car, absolutely nothing of the srs system is required by any sanctioning body that a roll cage and proper race harnesses won't replace.

Forum: Engine, Exhaust, Transmission

10-31-2022, 07:42 PM

Replies: 8

Grinding or rubbing

Views: 801

Posted By Ultramaroon

Circlip should just pop into the detent. Tap it...

Circlip should just pop into the detent. Tap it with a plastic mallet or a dead-blow.

Or how I've done it is to just pull it out a little more and give it a good shove by hand.

Forum: Engine, Exhaust, Transmission

09-26-2022, 02:31 AM

Replies: 17

Wont go into gear

Views: 2,471

Posted By Ultramaroon

I get what you're saying about using a torque...

I get what you're saying about using a torque wrench at the bottom of its range. It's good to have the overlap.

I don't think a slight over-torque did any damage, or would have rendered the...

Forum: Engine, Exhaust, Transmission

12-12-2021, 03:48 PM

Replies: 8

Whiteline

Views: 1,308

Posted By whataboutbob

You're not the first, or the last to have these...

You're not the first, or the last to have these fail in this way. They'll likely send you a new set, but I ended up going with the SPL units...

Forum: Engine, Exhaust, Transmission

11-11-2021, 10:02 PM

Replies: 6

Weight

Views: 1,206

Posted By Grady

These cars are light and you have taken more...

These cars are light and you have taken more weight off the rear. Just because you are spinning does not mean the car will not accelerate well of the line. No mater what you do you have more HP than...

Forum: Engine, Exhaust, Transmission

10-04-2021, 01:13 PM

Replies: 3

Manual swap

Views: 911

Posted By PulsarBeeerz

You'll never have to worry about the trans...

You'll never have to worry about the trans handling the power again.

https://www.mazworx.com/mazworx-favq-transmission-adapter-kit-frs/brz.aspx

Forum: BRZ First-Gen (2012+) -- General Topics

07-13-2021, 08:53 AM

Replies: 4

Pov

Views: 825

Posted By Chuckls

If it didn't work, I wouldn't have recommended...

If it didn't work, I wouldn't have recommended it. But you do you.

Forum: BRZ First-Gen (2012+) -- General Topics

07-01-2021, 01:25 PM

Replies: 4

Tranny upgrade

Views: 965

Posted By NoHaveMSG

Looks like the only mods 86Tokoyo had on his auto...

Looks like the only mods 86Tokoyo had on his auto was a VB and trans cooler.

https://www.ft86club.com/forums/showthread.php?t=141706

Forum: BRZ First-Gen (2012+) -- General Topics

05-14-2021, 07:00 PM

Replies: 11

Alignment

Views: 1,617

Posted By Grady

Ok here is your list. ...

Ok here is your list.

https://www.kwik-lift.com/

https://www.longacreracing.com/products.aspx?itemid=2446&prodid=7252&pagetitle=Digital-C%2fC-Gauge-w-AccuLevel™-and-Quick-Set™-Adapter
...

Forum: BRZ First-Gen (2012+) -- General Topics

05-14-2021, 08:55 AM

Replies: 5

Drag

Views: 1,330

Posted By ZDan

Aero drag is not going to be up by much. Judging...

Aero drag is not going to be up by much. Judging by these results (https://ecomodder.com/forum/showthread.php/tire-width-vs-drag-cd-7475.html), 265 vs 215 might increase aero drag by ~5%.
Rolling...

Forum: BRZ First-Gen (2012+) -- General Topics

05-13-2021, 04:41 PM

Replies: 11

Alignment

Views: 1,617

Posted By NoHaveMSG

Both the shops I trust have alignment racks that...

Both the shops I trust have alignment racks that use these types of sensors. Fender clearance isn't an issue.

Forum: BRZ First-Gen (2012+) -- General Topics

04-04-2021, 12:42 PM

Replies: 12

Oil pressure sender

Views: 2,477

Posted By NoHaveMSG

I have a spare timing cover I was going to use...

I have a spare timing cover I was going to use for a project you can have for free, just pay shipping. PM me if you want it.

Showing results 1 to 15 of 15

Forum Jump

All times are GMT -4. The time now is 06:15 AM.

User Name		Remember Me?
Password