follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 500
Search took 0.72 seconds.
Search: Posts Made By: RedReplicant
Forum: Engine Swaps 04-22-2024, 04:00 PM
Replies: 292
Views: 70,079
Posted By RedReplicant
There are FA24 first gens running around with a...

There are FA24 first gens running around with a variety of sensor/harness configurations at this point, given that people stand to make money doing this the details are being kept fairly quiet. ...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-16-2024, 04:15 PM
Replies: 4
Views: 350
Posted By RedReplicant
Nah, as in a full size 22mm wrench is too long to...

Nah, as in a full size 22mm wrench is too long to adjust without being frustratingly slow. I cut mine down to be like fist length so I can more or less do a half turn at once instead of like a...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-16-2024, 12:40 PM
Replies: 4
Views: 350
Posted By RedReplicant
Yep, RockAuto Moogs (same thing as SPC) with some...

Yep, RockAuto Moogs (same thing as SPC) with some lockout plates. GKTech had the cheapest lockout plates I could find without resorting to cutting metal myself when I was last looking.

Only...
Forum: Member's Car Journals 04-16-2024, 12:21 PM
Replies: 264
Views: 35,173
Posted By RedReplicant
I told myself it was for fun but we all know...

I told myself it was for fun but we all know that's a lie. :bellyroll:

I weighed it a few days ago and it came out lighter than I expected by about a hundred pounds, and there is another 50lb to...
Forum: Member's Car Journals 04-13-2024, 12:06 AM
Replies: 264
Views: 35,173
Posted By RedReplicant
Lotus has needed a lot of little things sorted. ...

Lotus has needed a lot of little things sorted.

I had to redo the entire cockpit layout in terms of seat, seat mount, moving the shifter, lowering the steering column, etc since it was set up for...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 04-03-2024, 12:22 PM
Replies: 367
Views: 252,619
Posted By RedReplicant
No

No
Forum: Tracking / Autocross / HPDE / Drifting 03-27-2024, 01:59 PM
Replies: 62
Views: 5,229
Posted By RedReplicant
Painful to lose out on bump travel :( But...

Painful to lose out on bump travel :(

But yeah, I've noticed these cars are very, very sensitive to ride height. Over simplifying for making small balance changes but front for entry...
Forum: Member's Car Journals 03-26-2024, 01:38 PM
Replies: 264
Views: 35,173
Posted By RedReplicant
Thanks, Pat. It is hard for me to quantify...

Thanks, Pat. It is hard for me to quantify without doing a bit more testing, but I'm getting I could pull half a degree or a bit more out of the front and they'd be fine.... so like -4.25 area? ...
Forum: Tracking / Autocross / HPDE / Drifting 03-26-2024, 01:31 PM
Replies: 62
Views: 5,229
Posted By RedReplicant
If you're eating your fender liners fix your...

If you're eating your fender liners fix your front damper length
Forum: Member's Car Journals 03-25-2024, 07:22 PM
Replies: 264
Views: 35,173
Posted By RedReplicant
I had a bunch of fun at the 86Cup event - it was...

I had a bunch of fun at the 86Cup event - it was nice to dice it up in traffic a bit, met some people from Discord, took a couple of passengers, and was able to donate my spare CV shaft to a fellow...
Forum: Tracking / Autocross / HPDE / Drifting 03-24-2024, 02:53 PM
Replies: 698
Views: 204,750
Posted By RedReplicant
Had some fun at 86Cup Chuckwalla this weekend,...

Had some fun at 86Cup Chuckwalla this weekend, met some nice people, and donated a spare axle I'd had in my truck for a couple of years.

Couple of low 1:57 laps, one chasing a new M2 and one...
Forum: Engine Swaps 03-20-2024, 11:54 AM
Replies: 11
Views: 984
Posted By RedReplicant
Beautiful work on the rear subframe!

Beautiful work on the rear subframe!
Forum: Member's Car Journals 03-19-2024, 01:12 PM
Replies: 264
Views: 35,173
Posted By RedReplicant
It was done by TC Design...

It was done by TC Design (https://www.tcdesignfab.com/) up in the San Jose, CA area. It looks really, really well done and it was a big part of why I bought the car in the first place. I'll be at...
Forum: Member's Car Journals 03-10-2024, 04:57 PM
Replies: 264
Views: 35,173
Posted By RedReplicant
I wanted to add some color to the car so I...

I wanted to add some color to the car so I grabbed some of the STI mirror covers from Japan

https://i.imgur.com/iGk3zdJ.jpeg

New window net and new Schroth harness went into the car, still...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 03-08-2024, 09:28 PM
Replies: 2
Views: 515
Posted By RedReplicant
After my experience with some of the other GKTech...

After my experience with some of the other GKTech stuff I will let someone else be the guinea pig, either way curious how these hold up on heavily beaten track cars.
Forum: Tracking / Autocross / HPDE / Drifting 03-08-2024, 12:25 PM
Replies: 62
Views: 5,229
Posted By RedReplicant
Below 140mm front pinchweld to ground, per 949

Below 140mm front pinchweld to ground, per 949
Forum: Engine, Exhaust, Transmission 03-05-2024, 05:58 PM
Replies: 27
Views: 1,585
Posted By RedReplicant
This is not my experience, whatever you're...

This is not my experience, whatever you're experiencing more than likely isn't the injectors. I am running them on my K24 swapped car, it idles like stock and there are zero issues starting hot on...
Forum: Tracking / Autocross / HPDE / Drifting 02-27-2024, 04:40 PM
Replies: 70
Views: 18,067
Posted By RedReplicant
I ended up regrettably selling the 14ft...

I ended up regrettably selling the 14ft Featherlite since the car hung off the back too much for my liking and was a nightmare to tie down. I think it'd be fine if you had no splitter so you could...
Forum: Member's Car Journals 02-27-2024, 02:32 PM
Replies: 264
Views: 35,173
Posted By RedReplicant
I'll give it a shot, I ordered a set of R12/R10...

I'll give it a shot, I ordered a set of R12/R10 from you and another set of Centric blanks to bed them in on.

I'm kinda tempted to run the car in a TREC enduro occasionally so I sent my fire...
Forum: Tracking / Autocross / HPDE / Drifting 02-20-2024, 02:10 PM
Replies: 698
Views: 204,750
Posted By RedReplicant
Nah, I built it :) Slowly getting it more...

Nah, I built it :) Slowly getting it more dialed.

949 did a 1:56:898 on a 265 SuperCar 3R.

https://www.youtube.com/watch?v=gk35Rf9isbA
Forum: Member's Car Journals 02-19-2024, 01:31 PM
Replies: 264
Views: 35,173
Posted By RedReplicant
Thank you, an attempt was made :) A few...

Thank you, an attempt was made :)

A few other notes... I'm calling my electric power steering cut issues done. Back in October-ish I made some front damper length and sway bar endlink changes. ...
Forum: Member's Car Journals 02-18-2024, 07:50 PM
Replies: 264
Views: 35,173
Posted By RedReplicant
This was A Weekend. There were 350 cars or...

This was A Weekend. There were 350 cars or something at the event and like 11-12? total in TT5.

On Friday I went to go pick up my trailer and I found that some beautiful person decided they...
Forum: Tracking / Autocross / HPDE / Drifting 02-18-2024, 07:25 PM
Replies: 698
Views: 204,750
Posted By RedReplicant
Updated the NASA SoCal / NASA AZ Chuckwalla CW...

Updated the NASA SoCal / NASA AZ Chuckwalla CW TT5 lap record today, not a very clean lap but I feel pretty good about the time all things considered. I'm pretty positive there is a 1:55 in the car...
Forum: Member's Car Journals 02-15-2024, 05:22 PM
Replies: 264
Views: 35,173
Posted By RedReplicant
Few separate things before I head off to...

Few separate things before I head off to Chuckwalla this weekend.

I've wanted an AC/iRacing delta bar really badly but I don't want to pay for a Racelogic lap timer. A recent-ish AIM Solo2DL...
Forum: Engine Swaps 02-09-2024, 09:44 PM
Replies: 292
Views: 70,079
Posted By RedReplicant
Sorry, I missed the part where that year range...

Sorry, I missed the part where that year range was mentioned.
Forum: Engine, Exhaust, Transmission 02-08-2024, 06:48 PM
Replies: 11
Views: 832
Posted By RedReplicant
AAF is bringing their shifter to our chassis too,...

AAF is bringing their shifter to our chassis too, it'll be out soon.

https://advancedautofab.com/p/aaf-bmw-race-shifter-with-adjustable-shift-shaft/

https://i.imgur.com/ErBqmKo.png
Forum: Member's Car Journals 02-08-2024, 01:53 PM
Replies: 264
Views: 35,173
Posted By RedReplicant
To bring the motor mount thing full circle... I...

To bring the motor mount thing full circle... I ordered mounts for a WRX not realizing there are two different mounts listed as WRX.

Anchor 9023 and Anchor 9024 are both listed for a WRX but it...
Forum: Member's Car Journals 02-08-2024, 01:32 PM
Replies: 261
Views: 46,884
Posted By RedReplicant
edit: lol, the other forum is blocked by a filter...

edit: lol, the other forum is blocked by a filter here

https://i.imgur.com/PXV9UOb.png
Forum: Tracking / Autocross / HPDE / Drifting 02-07-2024, 11:38 AM
Replies: 34
Views: 2,522
Posted By RedReplicant
Dropping wheels hard has been the number one...

Dropping wheels hard has been the number one killer of wheel bearings across track cars for me. Not the normal curb hits, the ones that make you wonder if half the car broke off.
Forum: Engine Swaps 02-06-2024, 05:02 PM
Replies: 1,756
Views: 240,238
Posted By RedReplicant
Going to be testing this option for the shift...

Going to be testing this option for the shift selector rod here soon
https://www.instagram.com/p/C2-y-FmRolc/
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -4. The time now is 03:38 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.