follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.13 seconds. Search: Posts Made By: steve99
Forum: Software Tuning 07-05-2022, 05:52 AM
Replies: 3
Views: 1,951
Posted By steve99
you dont need the custom map it will likely cause...

you dont need the custom map it will likely cause weird issues with idle when the ecu transitions from overun to idle mode you ill likely over fuel it if you use the custom map.



all you need...
Forum: Software Tuning 07-02-2022, 07:40 PM
Replies: 3
Views: 1,951
Posted By steve99
you dont need custom map the stock table...

you dont need custom map


the stock table can effectivly disable overun fuel cut


go to ecutek maps
select folder Fueling then Overun
Forum: Software Tuning 06-26-2022, 06:36 PM
Replies: 741
Views: 376,881
Posted By steve99
Can do custom tunes if needed Oil run a...

Can do custom tunes if needed


Oil run a SN or better rated full synthetic in warm Australia climate id go 5w30


Penrite Enviro full synthetic or Nulon long life you can get those at...
Forum: Software Tuning 06-10-2022, 07:31 AM
Replies: 1,284
Views: 576,445
Posted By steve99
if your tuning with oft yes if your tuning with...

if your tuning with oft yes
if your tuning with ecutek maybe depends on ecu calid
Forum: Software Tuning 06-07-2022, 06:50 AM
Replies: 38
Views: 4,525
Posted By steve99
the standard ecutek FFS setup is quite harsh as...

the standard ecutek FFS setup is quite harsh as it actually hold the rpm 200 rpm above the rpm clutch was pressed. for smooth shifts you want to have the rpm hold between 200 less to 1200 rpm less...
Forum: Software Tuning 06-04-2022, 06:48 PM
Replies: 7
Views: 1,428
Posted By steve99
yes it you input a voltage to the evap to...

yes it you input a voltage to the evap to simulate a flex kit you can have multiple maps
Forum: Software Tuning 06-03-2022, 07:42 AM
Replies: 13
Views: 1,600
Posted By steve99
sent you private message

sent you private message
Forum: Software Tuning 05-30-2022, 03:55 AM
Replies: 10
Views: 1,956
Posted By steve99
Short answer no Ecutek tunes while the...

Short answer no


Ecutek tunes while the have whats referred to as map switching its not switching a complete tune.


Its only switching a small subset on maps like base fueling and timing. All...
Forum: Software Tuning 05-10-2022, 03:10 AM
Replies: 25
Views: 3,858
Posted By steve99
Yes i self tune and tune with Ecutek (and oft and...

Yes i self tune and tune with Ecutek (and oft and tactrix and kess)


If you want to self tune with ecutek using the standard ecu tables then you can do this with a base level ecutek kit and ecu...
Forum: Software Tuning 05-04-2022, 06:33 PM
Replies: 38
Views: 4,525
Posted By steve99
You can adjist the clutch detect switch to be...

You can adjist the clutch detect switch to be lessxsensitive, its the one thats at the start of clutch operation ie at top , fhe one that detects if clutch on floor is the start safety switch.

...
Forum: Software Tuning 05-04-2022, 06:12 AM
Replies: 38
Views: 4,525
Posted By steve99
Does your tune have FFS flat foot upshift enabled...

Does your tune have FFS flat foot upshift enabled ? if so it migh be the clutch detection switch faulty trigging the FFS function, or your resting foot slightly on clutch trigfering the FFS function...
Forum: Software Tuning 04-11-2022, 03:00 AM
Replies: 1
Views: 970
Posted By steve99
once you flash an ecutek tuned rom to car ie a...

once you flash an ecutek tuned rom to car ie a rom thats not 100% stock ecutek forces you to add racerom which locks ecu to other tools


only if you flash a stock rom to car will ecu be unlocked...
Forum: Software Tuning 02-22-2022, 04:28 PM
Replies: 7
Views: 2,219
Posted By steve99
[QUOTE=Tatsu333;3506396]Thanks again for all the...

[QUOTE=Tatsu333;3506396]Thanks again for all the info, and for that clarification - very helpful!

So - "Subaru Closed Loop" is the regular closed-loop functionality, "ECUTEK Closed Loop" is what...
Forum: Software Tuning 02-22-2022, 12:57 AM
Replies: 7
Views: 2,219
Posted By steve99
Note if you have not purchased the racerom...

Note if you have not purchased the racerom extension pack from your tuner you cannot access modes 2,3,4 or the advanced racerom fesatures like ecutel closed loop , flex fuel speed density as seen in...
Forum: Software Tuning 02-21-2022, 05:16 PM
Replies: 7
Views: 2,219
Posted By steve99
OK in the normal operation assuming you dont...

OK

in the normal operation assuming you dont have ecutek closed loop mode active

low throttle and cruise you generally in subaru closed loop mode

AFR is target is set by the Closed loop AFR...
Forum: Software Tuning 01-28-2022, 07:08 PM
Replies: 110
Views: 71,663
Posted By steve99
ok thats easy fix message me ill telk you how to...

ok thats easy fix message me ill telk you how to override ecutek rom id check
Forum: Software Tuning 01-28-2022, 05:15 PM
Replies: 110
Views: 71,663
Posted By steve99
ues if your getting that id say the new ecu is...

ues if your getting that id say the new ecu is programmed with an auto calibration


plug ecu in and read calid from ecu


if its auto calibration and tour car manual it wont start either
Forum: Software Tuning 01-27-2022, 04:31 PM
Replies: 110
Views: 71,663
Posted By steve99
https://www.gt86.org.uk/forums/forums/topic/5025-d...

https://www.gt86.org.uk/forums/forums/topic/5025-deactivate-alarm/


few post down is factpry alarm manual, we dont jave it in my country so i have zero knoledge on it
Forum: Software Tuning 01-05-2022, 05:16 AM
Replies: 110
Views: 71,663
Posted By steve99
Same process pish button start or key start, you...

Same process pish button start or key start, you only need to swap ecu nothing else
Forum: Engine, Exhaust, Transmission 11-10-2021, 04:52 PM
Replies: 21
Views: 3,486
Posted By steve99
Ok log appears to show there is fueling problem ...

Ok log appears to show there is fueling problem


High positive fuel trims and also the commanded afr is way leaner than actual afr, and commanded afr seems lean


ill answer your PM
Forum: Software Tuning 10-29-2021, 08:11 AM
Replies: 11
Views: 3,818
Posted By steve99
Allthe rom files are same size 1.2 Mbytes tune...

Allthe rom files are same size 1.2 Mbytes tune files are .bin files


xnl files are definitions for romraider


you need a .bin tune file
Forum: Software Tuning 10-14-2021, 03:49 AM
Replies: 2
Views: 918
Posted By steve99
Yes stores a bunch of data advance multiplier ...

Yes stores a bunch of data
advance multiplier
fuel trims
misfire counts
time dtc on
starts since reset
cels since reset
and more
Forum: Software Tuning 09-29-2021, 08:05 PM
Replies: 6
Views: 1,235
Posted By steve99
Turn ignition full on , but engine off, map...

Turn ignition full on , but engine off, map srnsor or guage should read 14 psi or 1 bar ie atmospheric if absolute or. 0 psi 0 bar if reliative





Also depends if your looking at reliative...
Forum: Software Tuning 09-27-2021, 05:15 PM
Replies: 2,150
Views: 503,019
Posted By steve99
Agree with tom.brz timing seems pretty...

Agree with tom.brz

timing seems pretty aggressive if your on petrol, you would need high quality petrol to run 29 degrees full throttle.
Forum: Software Tuning 09-24-2021, 01:11 AM
Replies: 25
Views: 6,394
Posted By steve99
Increase the values in the overun fuel resume...

Increase the values in the overun fuel resume tables say 200 rpm at the bottom end
Forum: Scion FR-S / Toyota 86 GT86 General Forum 09-06-2021, 05:35 AM
Replies: 66
Views: 10,819
Posted By steve99
Readi g thread seem the maintenwnce was done...

Readi g thread seem the maintenwnce was done after is started making bad noises but maybe im reading it wrong.


Video doesnt sound good does sound mechanical


Could try unplugging maf sensor...
Forum: Software Tuning 09-03-2021, 10:58 PM
Replies: 6
Views: 2,811
Posted By steve99
Yes any USA 2012-2016 manual car is compatible...

Yes any USA 2012-2016 manual car is compatible with ZA1JB01C firmware


also make sure oft is updated and you manually update the Template File from oft support site
Forum: Issues | Warranty | Recalls / TSB 09-03-2021, 01:02 AM
Replies: 9
Views: 1,838
Posted By steve99
Pretty normal for stft to move round a lot on...

Pretty normal for stft to move round a lot on large sharp throttle movenents that normal
Forum: Software Tuning 08-27-2021, 02:14 AM
Replies: 1,088
Views: 444,328
Posted By steve99
if you have thise two #af3 parameters just zero...

if you have thise two #af3 parameters just zero those i think the third one in some defs is redundant or a duplicate ecutek only has 2
Forum: Software Tuning 08-25-2021, 07:19 AM
Replies: 5
Views: 1,127
Posted By steve99
very likely that knock may be due to mechanical...

very likely that knock may be due to mechanical rattle or vibration of exhaist on chassis or skid plate fooling knock sensor


Pull 5 degrees out of the entire base b timing map


if knock...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -4. The time now is 12:10 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.