follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 56
Search took 1.77 seconds.
Search: Posts Made By: aagun
Forum: Software Tuning 04-02-2017, 10:37 PM
Replies: 131
Views: 44,457
Posted By aagun
ztan write the code if i dont miss anything

ztan write the code if i dont miss anything
Forum: Software Tuning 03-31-2017, 05:56 PM
Replies: 131
Views: 44,457
Posted By aagun
make money . and ignore people . lol Goodluck...

make money . and ignore people . lol
Goodluck oft users
Forum: Software Tuning 02-11-2017, 10:43 PM
Replies: 4
Views: 2,189
Posted By aagun
yes it is full rom 0x0000 - 0x14FFFF NOT yet...

yes it is full rom 0x0000 - 0x14FFFF

NOT yet . my ecu need same soldering . to be ready for unbrick it
i believe this rom will work right with out any issue . i was looking in it to be sure that...
Forum: Software Tuning 02-11-2017, 12:39 PM
Replies: 4
Views: 2,189
Posted By aagun
STARTER rom for FRS/BRZ/GT86/86 2013-2016

Hello

after long time looking for this rom . Finally i found it

idk if it worl or not .iam not test it yet but it should work fine


this Rom is for recover bricked ECM . so dont use it...
Forum: Software Tuning 02-08-2017, 06:18 AM
Replies: 63
Views: 14,681
Posted By aagun
thx for helping me with that tool i make it...

thx for helping me with that tool i make it really fast . i Stock ot to 0 avcs values . the only error i know it was intake retarded not fixed yet . no time to check int avcs limits

inform me ^^
Forum: Software Tuning 02-08-2017, 03:08 AM
Replies: 63
Views: 14,681
Posted By aagun
scavenging refrash the gas in the cylinder ....

scavenging refrash the gas in the cylinder . there are limit for it (peak power) set it over will lose more frash air and then lose tourqe . peak power hard to find .it takes many dyno runs and...
Forum: Software Tuning 02-07-2017, 01:53 PM
Replies: 63
Views: 14,681
Posted By aagun
my tool for overlap calculation CAM LUMPY TOOL...

my tool for overlap calculation
CAM LUMPY TOOL (https://www.dropbox.com/s/jmqqmbfb362urzk/cam%20lumpy.xlsx?dl=0)
Forum: Software Tuning 02-02-2017, 03:44 PM
Replies: 63
Views: 14,681
Posted By aagun
one minute . u wanna take off that dip. ........ ...

one minute . u wanna take off that dip. ........
that think Give you huge power at low mid range . happed becose of overlap the firing whats that mean . it means the intake and exhaust cam open in...
Forum: Software Tuning 02-02-2017, 07:32 AM
Replies: 63
Views: 14,681
Posted By aagun
i found when i patch adle code that the ecu do...

i found when i patch adle code that the ecu do alot of testing and checking when start in the engine . on AVCS.
keeping the engine out of troubles is one of major job by ecm . any disactives...
Forum: Software Tuning 01-27-2017, 03:46 AM
Replies: 20
Views: 7,379
Posted By aagun
iam working on that but ecutek worked hard to get...

iam working on that but ecutek worked hard to get it
Forum: Software Tuning 01-26-2017, 11:46 AM
Replies: 47
Views: 10,900
Posted By aagun
AVCS does affect your tune . if u run OL and...

AVCS does affect your tune . if u run OL and OVERLAPE it
ext avcs + intk avcs = 56+ will throw unburn fuel to the ext
Forum: Software Tuning 01-23-2017, 04:09 PM
Replies: 48
Views: 11,038
Posted By aagun
steve99 thx for helping i am not give...

steve99
thx for helping


i am not give up form old ecu . i know alot of ppl wanna unbrick sh72531 ecm
and there are many rom devrs can't hijack anything coz of bricks .


thx alot
Forum: Software Tuning 01-23-2017, 03:58 PM
Replies: 48
Views: 11,038
Posted By aagun
ecu changed . and the car work now after...

ecu changed . and the car work now after registration the ECM to key id
Forum: Software Tuning 01-21-2017, 05:37 AM
Replies: 48
Views: 11,038
Posted By aagun
i found ecu near me and cheap too i will pick...

i found ecu near me and cheap too i will pick up it . What i am doing here is try make solution
Forum: Software Tuning 01-19-2017, 02:44 PM
Replies: 8
Views: 2,303
Posted By aagun
try do same logs in air signs and compare it ...

try do same logs in air signs
and compare it

maf is so complex
Forum: Software Tuning 12-28-2016, 01:27 PM
Replies: 703
Views: 454,483
Posted By aagun
<table type="2D" name="Base Timing Idle...

<table type="2D" name="Base Timing Idle (In-Gear)(Above Speed Threshold) " category="Ignition Timing - Advance" storagetype="uint8" endian="big" sizey="9" userlevel="4">
<scaling units="Base...
Forum: Software Tuning 12-27-2016, 08:06 AM
Replies: 52
Views: 16,371
Posted By aagun
1 -1.5 bar at 93c from crank oil pressure sensor

1 -1.5 bar at 93c from crank oil pressure sensor
Forum: Software Tuning 12-23-2016, 10:17 AM
Replies: 52
Views: 16,371
Posted By aagun
https://youtu.be/nihZ3hKAGGI

https://youtu.be/nihZ3hKAGGI
Forum: Software Tuning 12-16-2016, 06:16 PM
Replies: 52
Views: 16,371
Posted By aagun
AVCS IDLE PATCHED (released)

Sorry for keeping the PATCH AWAY for long time . i decide release the PATCH for public

only supported By ZA1JA01G
Rom-rider definitions
WARNING : Using the PATCH at your own risk



update...
Forum: Software Tuning 12-11-2016, 09:29 PM
Replies: 44
Views: 17,383
Posted By aagun
mine set to 7550 - 7600 . 7550 = -20 degs +...

mine set to 7550 - 7600 . 7550 = -20 degs + 10.5 AFR
Forum: Software Tuning 11-27-2016, 12:53 PM
Replies: 703
Views: 454,483
Posted By aagun
my advice is to wait oft ecufash or ecutek guys...

my advice is to wait oft ecufash or ecutek guys def it . either way debugging by ur self. i use JA01G and JA01J roms . ja01c different from above . i will have look at that new roms
Forum: Issues | Warranty | Recalls / TSB 10-10-2015, 11:41 PM
Replies: 76
Views: 23,206
Posted By aagun
http://www.ft86club.com/forums/showthread.php?t=94...

http://www.ft86club.com/forums/showthread.php?t=94377
Forum: Software Tuning 10-05-2015, 12:42 PM
Replies: 5
Views: 1,805
Posted By aagun
thats AVCS advancing

thats AVCS advancing
Forum: Issues | Warranty | Recalls / TSB 09-25-2015, 07:24 AM
Replies: 17
Views: 14,128
Posted By aagun
check ur fuel regulator

check ur fuel regulator
Forum: Engine, Exhaust, Transmission 09-08-2015, 06:34 PM
Replies: 22
Views: 7,011
Posted By aagun
http://dc440.4shared.com/img/KwXkWqE1ba/s7/14faa0d...

http://dc440.4shared.com/img/KwXkWqE1ba/s7/14faa0d3b30/20150821_114935?async&rand=0.38926552931422564
...
Forum: Engine, Exhaust, Transmission 09-07-2015, 06:17 AM
Replies: 22
Views: 7,011
Posted By aagun
camshafts aee in good condition there are no...

camshafts aee in good condition there are no Scratchs or porting marks that let the cam clearance go far .
Forum: Software Tuning 07-12-2015, 09:40 PM
Replies: 15
Views: 3,834
Posted By aagun
WHAT IF WE ADD THAT CODES TO THE ROM IS IT WORK ?

WHAT IF WE ADD THAT CODES TO THE ROM IS IT WORK ?
Forum: Issues | Warranty | Recalls / TSB 07-05-2015, 06:38 PM
Replies: 9
Views: 3,031
Posted By aagun
http://dc313.4shared.com/img/EKoS4a34ba/s7/14e6058...

http://dc313.4shared.com/img/EKoS4a34ba/s7/14e60585ac0/20140719_070813?async&rand=0.5968385912442036
...
Forum: Engine Swaps 06-29-2015, 06:00 AM
Replies: 165
Views: 113,470
Posted By aagun
what if i swap 3uz and connect swap ecu with fa20...

what if i swap 3uz and connect swap ecu with fa20 ecus with CANBUS
do you guys think it can hear each other?


or if i use OP2 or ecutek to take off the cel code ?? is it work?
Forum: Engine, Exhaust, Transmission 06-19-2015, 02:34 PM
Replies: 12
Views: 7,744
Posted By aagun
push the limit of fa20 . God bless you

push the limit of fa20 . God bless you
Showing results 1 to 30 of 56

 
Forum Jump

All times are GMT -4. The time now is 05:08 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.