follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 2 1 2
Showing results 1 to 30 of 45
Search took 2.69 seconds. Search: Posts Made By: Var
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-24-2020, 06:17 PM
Replies: 34
Views: 5,126
Posted By ZDan
Damrite! :cheers:

Damrite!
:cheers:
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 11-23-2020, 03:41 PM
Replies: 3
Views: 815
Posted By burnt_toast
I reached out to the owner of this BRZ a while...

I reached out to the owner of this BRZ a while back and he said clearance for the Ampliforms was close but they cleared the pp Brembos. Maybe a 2-3mm spacer to be safe.
...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 11-22-2020, 11:37 PM
Replies: 3
Views: 815
Posted By DarkPira7e
I vote hypergrams. They do fit over PP brakes in...

I vote hypergrams. They do fit over PP brakes in that size/offset, I've seen them used on a PP BRZ
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-03-2020, 01:29 AM
Replies: 32
Views: 5,053
Posted By Captain Snooze
Damping > spring rate.

Damping > spring rate.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 07-11-2020, 07:08 PM
Replies: 491
Views: 156,059
Posted By itschris
Only if you're changing height via preload. If...

Only if you're changing height via preload. If instead you get extended bottom shock mounts, it sounds like the FLAs will work closer to how they were designed. The adjustability on the dampers...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 07-10-2020, 03:06 PM
Replies: 491
Views: 156,059
Posted By timurrrr
Yeah perhaps the middle point has the same motion...

Yeah perhaps the middle point has the same motion ratio. I was just pointing out that you should double check that.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 07-10-2020, 02:46 PM
Replies: 491
Views: 156,059
Posted By timurrrr
I don't know a simple answer, especially now that...

I don't know a simple answer, especially now that you have non-standard geometry in the rear, that changed motion ratios.

A complicated answer that I do know is:

Find out the Nm/º stiffness of...
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 07-09-2020, 01:50 PM
Replies: 2,589
Views: 461,753
Posted By Spuds
Correct

Correct
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-16-2019, 04:34 AM
Replies: 126
Views: 39,069
Posted By Captain Snooze
View from rear: Zero 182673 ...

View from rear:


Zero
182673



-5 deg
182674
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-15-2019, 07:44 PM
Replies: 8
Views: 1,844
Posted By Tristor
I went down this road. My car has everything in...

I went down this road. My car has everything in the SPL catalog on it and all the driveline stuff is the JDM STI mounts, Whiteline bushing toppers for the diff. Reason I didn’t go solid mounts for...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-15-2019, 04:15 AM
Replies: 8
Views: 1,844
Posted By mkivsoopra
I have almost solid everything... some...

I have almost solid everything... some combination of SPL arms, SPL subframe bushings, Cusco replacement bushings, Salasko diff bushings, Revolution bushings on the front LCA, custom solid...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 09-03-2019, 12:11 AM
Replies: 491
Views: 156,059
Posted By CSG Mike
Any bolt-on level of aero will not make enough...

Any bolt-on level of aero will not make enough downforce to bottom these out. If you have a well developed aero package making GT3 class levels of downforce, you'll need a different set of dampers,...
Forum: Engine, Exhaust, Transmission 08-14-2019, 06:42 AM
Replies: 2
Views: 919
Posted By ermax
This calculator right here is hands down the best...

This calculator right here is hands down the best I’ve ever seen. The URL is crazy long with all the specs from the gearbox embedded in it so the site generates short URLs with goo.gl. This short URL...
Forum: Forced Induction 05-21-2019, 08:16 AM
Replies: 104
Views: 29,475
Posted By Yoshoobaroo
I CANT MAKE A DECISION!!! Jrsc or edelbrock.

Harrop. It uses the same blower as the Edelbrock but in a better (IMO) designed manifold. It's lighter, lower, has better cooling, better flow, doesn't need a 'D-box' to fix the MAF issues the...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-12-2018, 03:21 PM
Replies: 4
Views: 1,416
Posted By brz fred
you'll need software, try the bleeding the master...

you'll need software, try the bleeding the master and doing all the calipers again. if it's still not there I'd just bite the bullet and pay a respectable shop their hour labor or w/e and have them...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-12-2018, 12:03 PM
Replies: 4
Views: 1,416
Posted By brz fred
before you take off the master, try pumping it up...

before you take off the master, try pumping it up and cracking open the lines on master cylinder one at a time, I normally don't have to bench bleed it. When I have customers come in w/ broken lines...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-28-2018, 10:26 PM
Replies: 8
Views: 3,736
Posted By churchx
May depend on how agressive pads are to rotors....

May depend on how agressive pads are to rotors. But usually rotors outlast pads. I'm through 3rd pad set (on non PP, OE brakes), and it looks, like my rotors will get through 4th, for example. Just...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-26-2018, 02:52 PM
Replies: 4,438
Views: 1,136,079
Posted By strat61caster
Yes, if you adjust two adjacent corners of the...

Yes, if you adjust two adjacent corners of the car equally, i.e. front/rear or left/right it should have negligible to zero impact on the corner balance.

Corner balance isn't that sensitive on a...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-24-2018, 07:31 PM
Replies: 491
Views: 156,059
Posted By Bimble Bamble
5 month follow up: TRD sways, Whiteline LCAs,...

5 month follow up: TRD sways, Whiteline LCAs, thats it
Install: They came sent to me at about stock height, i went to 2 fingers on all and they didnt settle too much from there.

-Street: Full...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-17-2018, 12:47 AM
Replies: 16
Views: 7,286
Posted By CSG David
For beginners to advanced users; for competition...

For beginners to advanced users; for competition aero to no aero; for OEM tire to full slicks; and for full loaded weight to stripped - the CSG Spec TEIN Flex A was developed around these tested...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-16-2018, 06:36 PM
Replies: 16
Views: 7,286
Posted By Leonardo
245/40/17 is stock diameter and fits nicely on a...

245/40/17 is stock diameter and fits nicely on a 17x9. Tire rack has 75 options.


17x9 is a common size. I'd suggest a +40 to +30 offset, depending on how want them to look.


IMO, I...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 11-02-2017, 03:12 PM
Replies: 11
Views: 4,717
Posted By Tcoat
If you unplug it in a flat neutral place it will...

If you unplug it in a flat neutral place it will be centered. Once unhooked from the sensor it will not move.
Forum: Engine, Exhaust, Transmission 09-15-2017, 12:37 PM
Replies: 8
Views: 2,223
Posted By cbryant514
Here is a nicely detailed thread post for trunk...

Here is a nicely detailed thread post for trunk sound barrier installation:
http://www.ft86club.com/forums/showpost.php?p=1389856&postcount=5

Scroll past the headliner portion to get to the the...
Forum: Engine, Exhaust, Transmission 09-14-2017, 08:31 PM
Replies: 8
Views: 2,223
Posted By Spocknasty
I'll get some this weekend.

I'll get some this weekend.
Forum: Engine, Exhaust, Transmission 09-07-2017, 09:34 PM
Replies: 8
Views: 2,223
Posted By Spocknasty
I used Stinger RKX36B Roadkill Expert Series...

I used Stinger RKX36B Roadkill Expert Series Sound Damping. Easy to apply, I recommend using a roller tool to ease and improve the application. I added some to the top of the area where the...
Forum: Engine, Exhaust, Transmission 09-06-2017, 11:02 PM
Replies: 8
Views: 2,223
Posted By Spocknasty
I have the Borla catback and UEL Header with the...

I have the Borla catback and UEL Header with the factory front pipe. The drone is quite pronounced. I applied sound deadening mat to the trunk area to combat it, with noticeable effect.
Forum: Engine, Exhaust, Transmission 07-25-2017, 04:09 PM
Replies: 3
Views: 1,427
Posted By thetyrant
Check out this thread -...

Check out this thread - http://www.gt86.org.uk/forums/topic/4529-my-custom-hayward-and-scott-cat-back-design-and-proving/
Forum: BRZ First-Gen (2012+) -- General Topics 05-17-2017, 02:49 PM
Replies: 84
Views: 30,222
Posted By nikitopo
I also heard good news about the Sachs shocks....

I also heard good news about the Sachs shocks. Keep in mind that some other parts have changed too. E.g., the front top mounts are new ones. Probably, because the front springs are much stiffer.

...
Forum: BRZ First-Gen (2012+) -- General Topics 05-17-2017, 12:06 PM
Replies: 84
Views: 30,222
Posted By Azzudien
Long post sorry: My official review of the...

Long post sorry:

My official review of the 2017PP. Made it through the break in period no issues, already had the feeling I was loving the car. May 15th comes and I am sitting at Thompson Motor...
Forum: BRZ First-Gen (2012+) -- General Topics 04-18-2017, 06:35 AM
Replies: 84
Views: 30,222
Posted By bobabreath
I test drove one with the Performance Package...

I test drove one with the Performance Package last weekend. I was most impressed by the updated suspension. Much more refined, controlled, and less bumpy. Brakes are very solid. The higher final...
Showing results 1 to 30 of 45
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 02:42 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.